Paradyne HOTWIRE 7900 User manual

7900-A2-GK41-00 December 2000 1
Hotwire®TDM SDSL Termination Unit
Ferrite Choke
Installation Instructions
Document Number 7900-A2-GK41-00
December 2000
A ferrite choke is included with this Hotwire®TDM SDSL Termination Unit, which
needs to be installed on the DSL network cable.
CAUTION
When ferrite chokes are supplied, they must be installed following
these instructions to be in compliance with FCC Part 15, VCCI, and
CISPR22 rules.
Procedure
To install the ferrite choke on the DSL network cable:
1. Open the ferrite choke and place it around the cable, as close to the
termination unit as possible.
2. Close the two halves around the cable and snap the latch shut.
Hotwire is a registered trademark of Paradyne Corporation.

*7900-A2-GK41-00*
00-16917
Ferrite Choke
Plastic
Latch
Connector
Copyright ©2000 Paradyne Corporation. Printed in U.S.A.