Paris Rhone PE-HE001 User manual

IMPORTANT SAFETY INSTRUCTIONS
BEFORE USING THIS APPLIANCE READ ALL INSTRUCTIONS AND CAUTIONARY MARKINGS
IN YOUR USER MANUAL AND ON THE APPLIANCE
INTENDED USE
· This heater is not intended for use in bathroom, laundry areas and similar moist indoor
locations. Never locate heater where it may fall into a bathtub or other water container.
· Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
· The output of this heater may vary and its temperature may become intense enough to burn
exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to
heat or an inability to react to avoid burns.
ELECTRICAL SAFETY
· Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic
area and where it will not be tipped over.
· It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet
(receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified
electrician to replace loose or worn outlet.
· To disconnect the heater, first turn it off, then remove plug from outlet. Never pull by the cord.
· Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or
reloadable power tap (outlet/power strip).
RELATED TO USE
· This heater is hot when in use. To avoid burns, do not let bare skin touch hot surface.
Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at
least 3 feet (0.9m) from the front of the heater.
· Extreme caution is necessary when this heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
· Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has
been dropped or damaged in any manner. Discard heater or return heater to authorized
service facility for examination, electrical or mechanical adjustment, or repair.
· Do not use the heater outdoors.
· To prevent a possible fire, do not block air intakes or exhausts in any manner.
· Do not use on soft surface, like a bed, where openings may become blocked.
· A heater has hot and arcing or sparking parts inside. Do not use it in the areas where gasoline,
paint, or flammable liquids are used or stored.
· Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
· Always unplug the heater when not in use.
· Never tamper with the heater or attempt to fix it. Any tampering with, or modification of this
product can result in serious injury, death, or fire, risk of electric shock. Do Not open. No user
serviceable parts inside.
· DO NOT remove product labels that contain warnings or safety instruction.
· Before cleaning, or storage, or when not in use, turn the heater off and unplug it.
Input
Rated Power
Remote Control Battery
Specifications
120V~ 60Hz
1500W (High)
900W (Low)
AAA 1.5V (not included)
PTC FAN HEATER
User Manual
PE-HE001
READ ALL INSTRUCTIONS BEFORE
USING THIS HEATER.
SAVE THESE INSTRUCTIONS
Air Outlet
Control Panel Display
Base
Knowing Your Heater

Other Features
[email protected]
Manufacturer: Shenzhen NearbyExpress Technology Development Co.,Ltd.
Address: Floor 7, Building E, Galaxy World Phase II, Shenzhen, China
www.parisrhone.co
Made In China
Rev_1.0-EN
Using Your Humidifier
On/Off
Turn on/Standby mode. (Default: 95°F, HI Level)
After power off, the fan inside continues working for 15s
to cool down the unit.
Mode
Cycle through High (HI), Low (LO), ECO modes.
Menu (on remote control)
Turn on/off ECO mode.
+/-
Adjust temperature (41-95°F).
Hold both buttons to switch temp format.
When it reaches the preset temperature, the heater will stop
working. When it falls below the preset temperature, the heater
will resume.
Oscillation
Start/stop oscillation.
Hold to cancel the auto display off function.
Timer
Set the timer for auto-off (0-12 h).
Hold to turn off the timer.
Memory
Function
The heater
always remembers
your last settings
once you turn
it on again.
12-hour
Auto Off
The heater shuts
off automatically
after continuous
working for
12 hours.
Tip-over
Protection
The heater shuts
off automatically
if it is tipped over.
Overheat
Protection
The heater shuts
off automatically
if the ambient
temperature
is above 122°F.
Intertek
3068797
CM
Questions or Concerns?
[email protected]
When ECO mode is turned on, the heater will adjust the working mode (High or Low)
automatically based on the ambient temperature.
Place the heater on a firm, level surface free from obstructions, and at least 3 ft (90 cm) away
from any wall or combustible material. Plug into an appropriate socket and it is ready for use.

尺寸：120*160mm
材质：128克铜版纸
折页