Park Safe PS7006 User manual

UP
MENU
DOWN
VIDEO CHANNEL
POWER
Monitor / Remote Key Funcons
1. Power On/O
2. Video Channel
3. Decrease
4. Increase
5. Mode
6. Menu
7. Baery cover,
(Remove plasc sheet before using)
PS7006
USER MANUAL
1 2

UP
MENU
DOWN
VIDEO CHANNEL
POWER
Monitor / Remote Key Funcons
1. Power On/O
2. Video Channel
3. Decrease
4. Increase
5. Mode
6. Menu
7. Baery cover,
(Remove plasc sheet before using)
PS7006
USER MANUAL
1 2

Please Note - Depending on how your equipment has been installed , not all funcons
will apply.
 If you installaon required 1 camera, the monitor generally turns on when you
put your vehicle into reverse, and pressing the V1/V2 buon will give you a blue
screen saying “No Signal”. V1/V2 is never used in a 1 camera install.
• If your installaon required 2 cameras, generally the monitor is always powered and
displays an image, and when placing the vehicle into reverse the picture swaps on the
screen. And you can swap between the camera by using the V1/V2 buon
Press the power buon to turn your monitor on
3 4
How to use your Monitor
Press the MENU buon to scroll through the menu, using the UP and DOWN
arrows to alter each seng
Please note - Menu opons and order can change
Press the M buon and the menu will appear on the screen , if you press the M
buon again the next opon will appear on the screen (Like above)
Brightness - This opon changes the brightness of the picture
Contrast - This opon changes the contrast of the picture
Colour - This opon changes the colour of the picture
Mode - This opon changes the screen size
Tcon - This opon changes the rotaon of the screen
Language - This opon alters the language of the menu
Volume - This opon alters the volume if your camera has an audio funcon, if you
camera does not have an audio funcon we recommend the volume to be o
Reset - This opon will reset the monitor back to the original sengs
How to use your Monitor

Please Note - Depending on how your equipment has been installed , not all funcons
will apply.
 If you installaon required 1 camera, the monitor generally turns on when you
put your vehicle into reverse, and pressing the V1/V2 buon will give you a blue
screen saying “No Signal”. V1/V2 is never used in a 1 camera install.
• If your installaon required 2 cameras, generally the monitor is always powered and
displays an image, and when placing the vehicle into reverse the picture swaps on the
screen. And you can swap between the camera by using the V1/V2 buon
Press the power buon to turn your monitor on
3 4
How to use your Monitor
Press the MENU buon to scroll through the menu, using the UP and DOWN
arrows to alter each seng
Please note - Menu opons and order can change
Press the M buon and the menu will appear on the screen , if you press the M
buon again the next opon will appear on the screen (Like above)
Brightness - This opon changes the brightness of the picture
Contrast - This opon changes the contrast of the picture
Colour - This opon changes the colour of the picture
Mode - This opon changes the screen size
Tcon - This opon changes the rotaon of the screen
Language - This opon alters the language of the menu
Volume - This opon alters the volume if your camera has an audio funcon, if you
camera does not have an audio funcon we recommend the volume to be o
Reset - This opon will reset the monitor back to the original sengs
How to use your Monitor