PARK WAREHOUSE Cambridge User manual

8ft Cambridge Park Bench

Before assembly, please make sure all components are included.

Before assembly, please make sure all fasteners are included.
Also needed for this assembly will be the following materials:

Fig
In
steps. later in referenced
be will and numbered are positions
board the process assembly the through
going while easier Bench Cambridge
this of assembly the make to order
#1:
Note:
Stand
detail. show to only is View
ground. on flat ends bench
Step
Stand
Note: step. later a in done be will This completely. screw tighten not Do
end. bench the of
side right the on hole pre-drilled the in Screw Phillips Head Pan 1/2" 1 x
#12 (1) with fasten aligned, properly are holes the After end. bench the
in holes pre-drilled the to holes pilot the align to sure being 1 position
on (A) board bench nose bull (1) place and upright end bench (1)
#1:

Step
Stand
Note: step. later a in done be will This completely. screws tighten not Do
end. bench the
of side right the on hole pre-drilled the in Screw Phillips Head Pan 1/2" 1
x #12 (1) with fasten aligned, properly are holes the After end. bench the
in holes pre-drilled the with holes pilot the align to sure being 1 position
on end, bench first the to attached already (A) board bench nose
bull the place and time, a at one upright, ends bench (3) other the
#2:

Step
Align
Note: step. this after completely screws tighten to sure Be
end. bench per Screw
Phillips Head Pan 1/2" 1 x #12 (1) with fasten aligned, properly are
holes the After ends. bench the of side left the on holes pre-drilled
the to (A) board bench nose bull the on holes pilot the
#3:
Step
Place
fasten. to hole
per Screw Phillips Head Pan 1/2" 1 x #12 (1) Use attach. to 1-3 Steps
Repeat 10. position on (A) board bench nose bull second a
#4:

Step
Repeat
fasten. to hole per Screw Phillips Head Pan 1/2" 1 x #12 (1) Use
5.& 4 positions on (A) boards bench nose bull attach to 1-3 Steps
#5:

Step
Repeat
fasten. to hole per Screw Phillips Head Pan 1/2" 1 x #12 (1) Use
9. & 2,3,6,7,8 positions on (B) boards bench attach to 1-3 Steps
#6: