PARK WAREHOUSE 488be105-2 User manual

6ft Cambridge Flat Park Bench
SKU: 2488be105-

Before included. are components all sure make please assembly,

Before assembly, please make sure all fasteners are included.
Also needed for this assembly will be the following materials:

Step #1:
Place the Center Bench Boards on a level surface with the pilot holes facing
up. On each side of the Center Bench Boards place (1) Side Bench Board
with the pilot holes closest to the Center Bench Boards and facing up.
Step #2:
Place (1) Bench End in position as shown above being sure to align the
pre-drilled holes to the pilot holes in the bench boards. After the holes are
properly aligned, fasten with (1) #12 x 2 1/2" Flat Head Phillips Screw per
hole to secure.
Note: Do not tighten screw completely. This will be done in a later step.

Step #3:
Place the remaining Bench Ends in position as shown above being sure to
align the pre-drilled holes to the pilot holes in the bench boards. After the
holes are properly aligned, fasten with (1) #12 x 2 1/2" Flat Head Phillips
Screw per hole to secure.
Note: Be sure to tighten all screws completely after this step.