PARK WAREHOUSE 4ft Deluxe Park Bench User manual

4ft Deluxe Park Bench

Before assembly, please make sure all components are included.

Before assembly, please make sure all fasteners are included.
Also needed for this assembly will be the following materials:

Fig #1:
In order to make the assembly of this
Deluxe Bench easier while going through
the assembly process the board positions
are numbered and will be referenced in
later steps.
Step #1:
Stand (1) bench end upright and place (1) bench board on position 1 being
sure to align the pre-drilled holes to the pilot holes in the bench end. After
the holes are properly aligned, fasten with (1) #12 x 3" Flat Head Phillips
Screw in the top pre-drilled hole.
Note: Do not tighten screw completely. This will be done in a later step.

Step #2:
Stand the other (2) bench ends upright, one at a time, and place the
bench board already attached to the first bench end, on position 1 being
sure to align the pilot holes with the pre-drilled holes in the bench end.
After the holes are properly aligned, fasten with (1) #12 x 3" Flat Head
Phillips Screw in topthe pre-drilled .hole
Note: Do not tighten screws completely. This will be done in a later step.

Step #3:
Align the bottom pre-drilled holes to the pilot holes in the bench end.
After the holes are properly aligned, fasten with (1) #12 x 3" Flat
Head Phillips Screw per hole.
Note: Be sure to tighten screws completely after this step.
Step #4:
Place a second bench board on position 7. Repeat Steps 1-3 to attach.
Use (1) #12 x 3" Flat Head Phillips Screw per hole to fasten.

Step #5:
Repeat Steps 1-3 to attach bench boards on positions 2,3,4,5 & 6
Use (1) #12 x 3" Flat Head Phillips Screw per hole to fasten.