5. ETHERNET
Install the Ethernet cable to the proper port on the gateway.
NOTE: Different Ethernet ports are used for a particular cell
carrier. Determine what cell carrier is used (LAT or LVW) by
looking at the product label on the gateway. Plug the other
end of the Ethernet cable into the open port on the S3C Case
Controller or into a CAT-5 Ethernet splitter.
LAT Cell Carrier Ethernet Connection
LVW Cell Carrier Ethernet Connection
6. CELL ANTENNA
Install both cell antennas on the outer most terminals as
shown; left and right side.
7. POWER SUPPLY
Plug the gateway power supply into a 120VAC outlet. The
illustration below shows the final product after installation
(LAT cell carrier shown). If the need for troubleshooting the
refrigerated case should arise, call the Support number on
the gateway.
Parker Hannin Corporation
Sporlan Division
206 Lange Drive • Washington, MO 63090 USA
phone 636 239 1111 • fax 636 239 9130
www.sporlan.com
SD-458 / 52019© 2019 Parker Hannin Corporation
⚠WARNING – USER RESPONSIBILITY
Failure or improper selection or improper use of the products described herein or related items can cause death, personal injury and property damage.
This document and other information from Parker Hannin Corporation, its subsidiaries and authorized distributors provide product or system options for further investigation by users having
technical expertise.
The user, through its own analysis and testing, is solely responsible for making the nal selection of the system and components and assuring that all performance, endurance,
maintenance, safety and warning requirements of the application are met. The user must analyze all aspects of the application, follow applicable industry standards, and follow the
information concerning the product in the current product catalog and in any other materials provided from Parker or its subsidiaries or authorized distributors.
To the extent that Parker or its subsidiaries or authorized distributors provide component or system options based upon data or specications provided by the user, the user is responsible
for determining that such data and specications are suitable and sufcient for all applications and reasonably foreseeable uses of the components or systems.
