Parker PowerStation RS Parts list manual

CTC Parker Automation A3-05752-100
RS PC Fan Filter Replacement
Replacement Instructions
These instructions explain how to replace the fan filter in the PowerStation
RS PC.
Warning For safety reasons, the PowerStation RS PC should be opened
only by qualified service personnel.
Warning Be sure to observe electrostatic discharge (ESD) precautions
while working inside the PowerStation RS PC.
To replace the fan filter, follow these steps:
1. Make sure that the RS PC is turned off.
2. Remove the two retaining screws located at the bottom of the fan
cover as shown below.
3. Pull the bottom of the fan cover away from the chassis as shown
below, and slide it downward, off the chassis.
Fan cover
Retaining screws
Fan cover

RS PC Fan Filter Replacement
2
CTC Parker Automation
4. Remove the old fan filterfrom the inside of the fan cover as shown
below.
5. Place the new fan filter in the cover as shown below.
6. Holding the filter in place, slide the flange at the top of the cover
into the space for it at the top of the fan opening as shown in the
illustration below. Then push the cover into place on the front of
the PC.
Fan filter inside cover
Fan cover

RS PC Fan Filter Replacement
CTC Parker Automation
3
7. Refasten the fan cover in place with the two retaining screws that
you removed in step 2.
Note: When you fasten screws, tighten them snugly, but do not over-
tighten.
Fan filter replacement is now complete. You may restart the RS PC.

RS PC Fan Filter Replacement
4
CTC Parker Automation