Pataco TURTLE SI8S User manual

Pataco AG
Looäcker 1
CH-9247 Henau, Switzerland
www.pataco.com - [email protected]
Int. Freecall: [phone]© Pataco AG 09/2014 release 2.0
Alarm 1
Alarm 2
Alarm 3
Alarm 2 Alarm 4
INSTRUCTION MANUAL
COMPONENT INSTRUCTION
Pataco TURTLE
SI8S TURTLE
Alarm 1:
Armed TURTLE triggers EAS systems.
MULTI ALARM TECHNOLOGY
SI8M TURTLE
Clutch
Speaker
Slot
LED
Mechanical switch
Battery cover
Alarm 2-4:
Anti-tamper, TURTLE will full alarm if sensor
wire is cut or dampered with.
EN
Socket
Slider
Silicon bumper
Sensivity switch
Rubber pad
Base plate
Tape clamp
Movement sensor
Transportation security clip

Pataco AG
Looäcker 1
CH-9247 Henau, Switzerland
www.pataco.com - [email protected]
Int. Freecall: [phone]
123
INSTRUCTION MANUAL
PRE-ALARMING
Pataco TURTLE
SI8S TURTLE
Use screwdriver to take the
Battery cover screw out.
HOW TO STOP ALARMING
SI8M TURTLE
Pre-Alarm
Small movement of the Turtle causes a pre-alarm
of three beeps
The pre-alarm acts as a deterrent.
Open battery cover as
indicator shows
EN
HOW TO CHANGE BATTERY
Pre-Alarm
Open the Turtle by placing the detacher onto the clutch.
The alarm will stop immediately.
Change battery

Pataco AG
Looäcker 1
CH-9247 Henau, Switzerland
www.pataco.com - [email protected]
Int. Freecall: [phone]
1 2 3
1 2
1
3
INSTRUCTION MANUAL
APPLICATION WITH PACKING STRAP
Pataco TURTLE
SI8S TURTLE
Place the magnetic detacher onto
clutch and press to open Turtle.
HOW TO REALEASE - APPLICATION WITH PACKING STRAP
SI8M TURTLE
Take out Turtle from packing
strap.
EN
APPLICATION WITH GLUE STRIPE
The surface of merchandise and Turtle
has to be cleaned with an alcohol pad
to ensure maximum glue force.
Remove the transportation
security clip
Insert base plate under the
cross of packing strap, make
sure packing strap is in the
slot of base plate.
Close Turtle on base plate and
press down until lock.LED
ashes once and speaker beeps
once indicate merchandize
protected.
Pull
Use the carton box as transport
device from cashier to stock!

Pataco AG
Looäcker 1
CH-9247 Henau, Switzerland
www.pataco.com - [email protected]
Int. Freecall: [phone]
234
5 6
123
7
INSTRUCTION MANUAL
APPLICATION WITH GLUE STRIPE
Pataco TURTLE
SI8S TURTLE
Close the Turtle then remove the
second release paper
SI8M TURTLE
Attach The TURTLE onto the
merchandise and press down to
make sure it sticks tight on the
merchandise.
EN
HOW TO REALEASE - APPLICATION WITH GLUE STRIPE
Place the ejecter onto the clutch
and press to open the TURTLE.
Take a glue stripe and remove
one release paper.
Stick the glue stripe into the
slot of base plate.
Place the end of the glue stripe
into the tape clamp.
Take out the end of the glue stripe
from tape clamp, hold the Turtle
tightly and pull the glue stripe
horizontally
Take o TURTLE from
merchandise.
Now LED ashes once and
speaker beeps once to indicate
merchandise is protected.

Pataco AG
Looäcker 1
CH-9247 Henau, Switzerland
www.pataco.com - [email protected]
Int. Freecall: [phone]
1-6 7 8
9 10
1
11
INSTRUCTION MANUAL
APPLICATION WITH SENSOR
Pataco TURTLE
SI8S TURTLE
Take o the release paper from the
sensor head.
SI8M TURTLE
Stick the sensor head onto
merchandise. Use a cable tie
for better holding if required
(optional)
EN
HOW TO REALEASE THE SENSING HEAD
Same as step 1 to 6 of
"Application with glue stripe".
Plug in the end of the sensor
cable into the socket.
Wiring the sensor cable around
the strain-relief.
Close the TURTLE and press
down until it locks.
HOW TO REALEASE - APPLICATION WITH SENSOR
Same as step 1 to step 3 of "How to realease - Application with Glue Stripe".
Take o the glued
sensor by rotating the
sensor head.

Pataco AG
Looäcker 1
CH-9247 Henau, Switzerland
www.pataco.com - [email protected]
Int. Freecall: [phone]
SPECIFICATION TURTLE
Frequency: 58kHz / 8.2MHz Lock: super or normal magnetic
Dimension: Ø65mm x 35mm Battery: CR2450
Color: black, white or customize Usage environment
Beep volume: 95dB Temperature: 0 ~ 40°C (32 ~ 104°F)
Battery life: 3 years Humidity: 20% ~ 85%
Alarm duration: 5 minutes
SPECIFICATION GLUE STRIPE
NOTES
• Workingindicator: 1.WhilelockingtheTURTLE,LEDashesonceandspeakerbeepsonce.
2. No LED ash when the TURTLE is armed.
3. During alarming, the speaker beeps continuously and LED ashes.
4. During Pre-Alarm speaker beeps three times.
• Lowbatteryindicator: LEDashes10timescontinuouslywhenbecomesarmed.
Please change battery when low battery indicates.
• DefectiveTURTLEmustbedulydisposed.ThebatteryandtheTURTLEmusttobedisposedofseparatelyfromeach
other and not be allowed to arrive into the household refuse.
• Pre-Alarmsensivity: Position1:lowsensitive(alowslargermovementswithoutalarming)
Position 2: medium sensitive (delivery status)
Position 3: high sensitive (alarm is triggered by small movements)
INSTRUCTION MANUAL
Temperature: 0 ~ 40°C (32 ~ 104°F) Humidity: 20% ~ 85%
Max strength after 30 minutes: 2800g / 20mm (stick 20mm width stripe on stainless metal under 23°C and 65% RH
Pataco TURTLE
SI8S TURTLE
SI8M TURTLE
EN