PB TEEN Beadboard Dresser Topper User manual

www.pbteen.com
Beadboard Dresser Topper
—Base & Mirror
Pre-assembly:
•Please read all instructions before beginning assembly.
•Two-adult assembly is recommended.
•Save all packing materials until assembly
is complete to avoid accidentally discarding
smaller parts or hardware.
Parts included:
A – Topper Mirror – 1 pc B – Topper Base – 1 pc C – Mirror Support – 1 pc
(for hanging Topper Mirror
on wall only)
Hardware Included:
D – Wooden Knob – 3 pcs E – Allen Key – 1 pc F – Knob Bolt – 3 pcs
(M4x32mm)
G– Long Phillip Screw – 3 pcs H – Short Phillip Screw – 8 pcs I – Mending Plate – 2 pcs
(#8x45mm) (#7x20mm) (70x40mm)
(for hanging Topper Mirror
on wall only)
J – Anchor – 3 pcs
(for hanging Topper Mirror
on wall only)
Tools Required: Phillip Head Screwdriver (not included)
Assembly:
1. On a soft, scratch-free surface, such as a carpet or rug, remove all the parts from boxes.
2. Determine the desired location of the piece and prepare all parts there first. Note: The Topper Mirror
(A) can be either mounted on the wall or attached to the Topper Base (B). Please refer to the
separate instructions for wall mounting.
3. Attach the Wooden Knobs (D) to the drawer by holding the Wooden Knob (D) over the pre-drilled hole
in the drawer front. Insert a Knob Bolt (F) from the interior of the drawer into the Wooden Knob (D)
and tighten with a Phillips Head Screwdriver. Repeat with other drawers.
1/2

4. Remove the Hex Bolts from each support rail on the back of the Topper Mirror (A) by using the Allen
Key (E). See illustration. Please keep these Hex Bolts for use in the next assembly step.
www.pbteen.com
5. Assemble the Topper Mirror (A) to the Topper Base (B) by using the support rails that were just
removed in Step 4. Re-align the support rails so that they cover the pre-drilled holes of both the
Topper Mirror (A) and the Topper Base (B), as shown below. Re-insert the Hex Bolts that were
removed in Step 4 through the pre-drilled holes of the support rail and into the pre-drilled holes on the
backside of the Topper Mirror (A) and the Topper Base (B). Tighten with the Allen Key (E).
6. Attach the assembled Dresser Topper (Base & Mirror) to the Dresser with the Mending Plates (I).
Align the pre-drilled holes of the Mending Plates (I) with the pre-drilled holes on the lower backside of
the Topper Base (B) and the top backside of the Dresser. Insert a Phillips Screw (H) through the pre-
drilled holes on the Mending Plate (I) and into the pre-drilled holes of the Topper Base (B) and the
pre-drilled holes on the top backside of the Dresser.
7. Hardware should be checked periodically for tightness.
Care Instructions:
•Avoid direct sunlight and excessive temperatures.
•Dust often using a clean, soft, dry and lint-free cloth.
•Slightly moisten cloth with water. A damp cloth holds dust and prevents scratching.
•Waxing is not recommended on lacquered finish.
2/2