PB TEEN Swoop Seat Chair User manual

Page 1 of 2
Swoop Seat Chair
Pre-Assembly:
•Please read all instructions before beginning assembly.
•Use the parts and hardware lists to identify and separate each of the components included.
•Save all packing materials until assembly is completed to avoid the accidental discarding of smaller
parts or hardware.
Important Safety Instructions:
•For your safety and convenience, assembly by two people is recommended.
•Do not tilt the chair back on two legs when seated.
Parts Included: Hardware Enclosed:
EFGH
ABCD
Assembly Instructions::
1. Insert Short allen head bolt (C) and spring washers (E) through holes on legs (G & H). Secure with the
Allen key (F) but do not fully tighten before all bolts are attached.
2. Place both leg sets (G & H) into the four plastic spacers (D), making sure the arrow marks on the legs
face upward. At the same time, adjust seat so it is aligned with the frame. Do not over tighten..
．(4) Foot caps ( A )
．(4) Long Allen Head Bolt 38mm ( B )
．(1) Short Allen Head Bolt 21mm ( C )
．(4) Plastic spacer ( D )
．(5) Spring washer ( E )
．(1) Allen key 4mm( F )
．(1) Seat
．(1) Leg (G)
．(1) Leg (H)

Page 2 of 2
3. Insert Long allen head bolts (B) and spring washers (E) through the legs and spacers (D) and through
the seat on all sides. Secure and fully tighten with the Allen key (F), including the center bolt from
step 1..
4. Insert the foot caps (A) into ends of legs (G &H).
5. Set the chair upright and re-tighten al bolts as needed. Assembly is complete.
G
G
E
C
F
1.
HH
2.
E
D
B
3.
D
F
A
4.
H
G
Care Instructions
•Wipe with a soft, dry cloth.
•To protect the finish, avoid the use of all chemicals and household cleaners.
www.pbteen.com