PB TEEN HAMPTON CLASSIC DESK HUTCH User manual

Date: 2013-Oct.-01
Rev: www.pbteen.com Page 1 of 3
HAMPTON CLASSIC DESK HUTCH
ASSEMBLY INSTRUCTION

Date: 2013-Oct.-01
Rev: www.pbteen.com Page 2 of 3
Important safety instructions:
•Please read all all instruction carefully before assembling this Hutch.
•For your safety, assembly by two or more adults is strongly recommended.
•Keep these instructions for future use.
•Use only vendor-supplied hardware to assembly this item. Using unauthorized hardware could jeopardize
the structural integrity of the item.
Pre- assembly:
•Remove all parts and hardware from the box and place them on a carpeted or scratch-free work surface.
The shipping box provides an ideal work surface.
•To avoid accidentally discarding small parts or hardware, please do not dispose of any contents until
assembly is complete.
•Two people are recommended for your safety and ease of assembly.
•Prior to starting the assembly, use the parts and hardware lists to identify and separate each of the pieces
included.
•The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
•Note: Do not fully tighten any of the bolts until all parts are in place. Failure to follow these instructions may
cause the bolts to misalign during assembly.
•Please use caution if using power tools to aid in assembly. Power tools can damage the hardware or split the
wood.
Hardware Included:
A – Mending Plate
B –Phillips head
Screw
(70x40x2mm)
7x15(mm)
2pcs 8pcs
Tools Required:
Phillips Head Screwdriver (not included). Do not use power drill as it may cause cracking.

Date: 2013-Oct.-01
Rev: www.pbteen.com Page 3 of 3
Assembly Instruction Steps:
1. Place the desk hutch on desk (sold separately) in an upright position, as shown below.
2. Allign pre-drilled holes of the Mending Plate (A) with the pre-drilled holes at the back of Desk and Hutch.
Insert the Phillips Head Screw (B) through the pre-drilled holes of the Mending Plate (A) into pre-drilled holes
at the back of Desk and Hutch then loosely tighten Philips Head Screw (B) with a Philips Head Screwdriver.
Do not fully tighten until all screws are in place. Repeat on the other side of desk for 2nd mending plate.
3. For setting up the Desk, refer to Desk’s Assembly Instruction.
4. Hardware should be checked periodically for tightness.
Care Instructions:
•Dust often using a clean, soft, dry and lint-free cloth.
•Blot spills immediately and wipe with a clean, damp, cloth.
•We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered
finish.
•Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.