Peachtree Audio Deepblue User manual

Wireless Music System
User Manual

Congratulaons on your Peachtree Audio deepblue purchase. We
recommend that you read this manually thoroughly so that you can
fully ulize this excing product. Please keep it for your records.
Package Content
Features
• 3.5 mm AUX IN jack to connect your MP3 player
• Bluetooth enabled to wirelessly play your music
•
• Main Unit × 1
•
(included) × 1
• Detachable power cord × 1
• 3.5 mm AUX IN cable × 1
• × 1
For your safety, read and follow this manual carefully to ensure
proper use of the product and avoid any danger or physical damage.
•
items, such as newspapers, tablecloths, curtains, etc. to avoid
1
®

•
on the apparatus.
•Keep the appliance away from rain and any moisture. Do not
•When the unit is suddenly moved from a cold environment to a
warm one, if moisture forms inside it, it may not operate properly.
To correct this problem wait about one hour for the moisture to
evaporate.
•The apparatus shall not be exposed to dripping or splashing,
no
apparatus.
•Do not expose the unit under direct sunlight or nearby objects
that radiate heat to avoid damaging the unit.
•The apparatus should be used in moderate climate.
•The plug of the appliance shall remain readily operable.
•
separate the appliance from the mains.
•
the power supply. To disconnect the product from the mains
power supply, you must unplug the power cord.
•Pull out the mains plug if the appliance is not to be used over a
•Disconnect the main plug during thunderstorms.
Servicing -
or removing covers may expose you to dangerous voltage. Refer all
Damage Requiring Service - Unplug this product from the wall outlet
•When the power-supply cord or plug is damaged.
•If liquid has been spilled, or objects have fallen into the product.
If the product has been exposed to rain or water.
•If the product does not operate normally by following the
•If the product has been dropped or damaged in any way.
WARNINGS
•
•
•
•
•
•
•
end of its service life, or during long periods of non-use.
•
•
•
•
•Replace only with the same or equivalent type.
•
IMPORTANT
•
•
environmentally friendly disposal.
This Transmier must be installed to provide a separaon distance
of at least 20 cm from all persons.
23

• Power supply: AC 100 – 240 V, 50 / 60 Hz
• 3 V (1 × CR2025)
• 140 W
• Output power: 240 W max.
• 0.45 W
• 10 meters open air
• AUX IN jack: 3.5 mm
• Bluetooth version: V 2.1 +EDR
CAUTION
RISK OF
ELECTRIC SHOCK
DO NOT OPEN
symbol within an
equilateral triangle is
intended to alert the
user to the presence
of un-insulated
“dangerous voltage”
within the product’s
enclosure that may
magnitude to
electric shock to
persons.
WARNING: TO
REDUCE THE RISK OF
ELECTRIC SHOCK DO
NOT REMOVE COVER
(OR BACK), NO USER
SERVICEABLE PARTS
INSIDE REFER
SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
point within an
equilateral triangle
is intended to
alert the user
to the presence
of important
maintenance
(servicing)
the literature
accompanying the
appliance.
For indoor use only.
earth provided.
FRONT PANEL
REAR PANEL
TOP PANEL
1.
2. (Volume down)
3. (Volume up)
4. AUX (Green) / Bluetooth®
(Blue) / Standby (Red) indicator
5. Remote sensor
6. AUX IN jack
7. AC Socket
2
7
4
1
6
5
3
45
®

8. Power
9. Bluetooth®switch
10. Mute
11. Previous
12. Bass+
13. Bass-
14. PAIRING
15. AUX switch
16. Play/Pause
17. Next
18. VOL+ (Volume up)
19. VOL- (Volume down)
REMOTE CONTROL
REMOTE CONTROL BATTERY
1.
2.
3.
4.
To power the player ON:
1. Plug AC cord into AC jack, and plug into a live AC wall outlet.
2. Press the [
or the [ Power]
player to ON mode.
3. Press and hold the [
top panel for 1 to 5 seconds or press the [ Power]
remote control to switch the player to Standby mode.
Note: To save power, the player will switch to economic standby mode
when the speaker is idle for 12 hours.
Before your start:
Your Bluetooth device (cellphon e,MP3 player, computer, etc.)
please refer to your Bluetooth device’s user manual for details on
Bluetooth pairing /searching /setup
to set the device’s
mode.
Pairing your Bluetooth device with the player
1.
Please Note: Maximum broadcast distance for Bluetooth in open
space is typically 33 feet. Walls and other obstrucons may reduce
this distance significantly
Press and hold the[
top panel for 5 seconds or the [PAIRING]
67
®
®
®
®
®
®
1913
1812
1711
1610
159
148

LED Status:
͵
͵
͵
2.
manual to link to the player. Typically, Bluetooth controls are
3. Search the device name “Peachtree BT ” on your Bluetooth device
listed and select it as your audio speaker.
4.
is established.
5. Pairing remains intact even when the player or the Bluetooth®
auto link with the last linked device when that device is in range.
Pairing your other Bluetooth®device
Previously Paired Devices:
Bluetooth®device, press and hold the [
[PAIRING]
the remote control for 2 seconds and repeat the above steps for
pairing your other Bluetooth®.
Pl
Once the device is paired the blue light will turn off aer 15
seconds
aying Bluetooth®Music
1. Once your device and the player are linked you can start to play
Bluetooth®music through the player.
2. Turn on the player and press the [
[Bluetooth®]
control to select the Bluetooth®mode, Blue light indicates for
Bluetooth®mode.
3.
4. Press the [ ]
5. Press the [ ]
immediately to skip the previous track.
6. Press the [ ]
Press again to resume it.
7. Press the [ / ] [ / ]
adjust the system volume.
Note:
89
Note:
If the pairing is unsuccessful, re-pair your Bluetooth®device with the
player and repeat the above steps.
Flashing quickly – No device paired
Flashing Slowly – Device pairing
Steady ON – Device paired
1. If you are using a smartphone as your source the audio playing will be
interrupted when there is an incoming call or when the user makes
a call.
finished.
Bluetooth®-enable device.
NOTE: Depending on the Bluetooth®device you are using, you may
on
need to manually go into media player mode on your device to control
®
®
®
®
®
®
®

1. Connect a sound source with a Line or headphon e analogue output
to play through your player as below hookup diagram shown.
2. Press the [
or press the [AUX]
AUX mode. Green light indicates AUX Mode also.
3. Set your personal audio player/ computer to PLAY.
Headphone socket
3.5mm jack cable
(included)
•iPhone /iPad /iPod models
•MP3 players
•CD walkman players
•Tape walkman players
•Personal computers or laptops
Note:
at maximum volume output level. Therefore, if the unit randomly
stops playing the music or becomes distorted, move the volume level
to minimum and wait for a while. The user can try to move up the
PROBLEM SOLUTION
There is no power
to the player
Ensure that the Power Switch of wall socket is
Ensure that the AC plug is securely connected
to the player and proper wall outlet.
Trouble pairing
device /computer
with the player
your iPhone®/iPad®/iPod®.
Make sure your device is working properly.
Check your device’s manual for details on
Bluetooth pairing and lin king.
Make sure your device supports the A2DP
linking /pairing. The pl ayer defaults to the
last linked device, so a new device may
need to be linked by press and hold the
[
pairing other device.
10 11
®
iPod®, iPhone®, and iPad®are trademarks of Apple Inc., registered in the U.S. and other countries.

Recycling
and electr
WARRANTY : 1 year parts and labor when used under normal
vered under our warranty.
Please contact Peachtree Audio at 704.391.9337 or email us at
[email protected] with a
onic equipment (WEEE). This means that this product must
be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling
electronic equipment.
Net weight: 6.3kg
12

13
Peachtree Audio
2405 120th Avenue NE
Bellevue, WA 98005
704.391.9337
www.peachtreeaudio.com
Service: 704.391.9337
FCC ID: VWPKW-B25BT
The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc., and any
use of such marks by Signal Path International is
under license.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, this is no guarantee that interference
will not occur in a particular installation.
This Class B digital apparatus complies with Canadian ICES-003.
responsible for compliance could void the user’s authority to operate
the equipment. Where shielded interface cables have been provided
If this equipment does cause harmful interference to radio or television
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna;
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected;
• Consult the dealer or an experienced radio/TV technician for