PEERLESS MOD-FPSKIT150 Instruction Manual

Installation and Assembly:
Modular Flat Panel Mount Kit for 32” - 60” (81 - 152cm)
LCD or Plasma screens
Model: MOD-FPSKIT150
Visit Peerless at www.peerless-av.co.uk
MOD-FPSKIT150 ISSUED 10-04-15 REV5
Max. Load Capacity: 60kg (132lbs)
For Technical Support call [phone]
Cathedral ceiling plate with ±60° tilt•
1475mm distance from ceiling to centre of screen•
1500mm extension pole, cuttable to desired length•
-5° to +20° tilt, lockable at 5° increments•
360° rotation•
Security screws provided•
Universalscreenadaptortsmountingpatternsupto700x400mm•
Landscape or portrait orientation•

MOD-FPSKIT150 ISSUED 10-04-15 REV5For Technical Support call [phone]
Visit Peerless at www.peerless-av.co.uk Page 2 of 4
WARNING
Do not begin to install your Peerless product until you have• read and understood the instructions and warnings contained in this Installation
Manual. If you have any questions regarding any of the instructions or warnings, please contact Peerless using the information on the
back of this manual.
This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction and fully•
understands these instructions.
Make sure that the supporting surface is in good condition and will safely support the combined load of the equipment and all attached•
hardware and components.
Never exceed the Maximum Load Capacity on Page One.•
If mounting to wood stud or joist, make sure that mounting screws are anchored into the centre of the studs. Use of an “edge-to-edge”•
studnderishighlyrecommended.
If mounting to concrete, breeze block, brick or other masonry material, do not drill into mortar joints. Ensure screw and anchor are•
installed into solid areas of surface.
Always use an assistant or mechanical lifting equipment to safely lift and position equipment.•
Tightenscrewsrmly,butdonotovertighten.Overtighteningcandamagethescrews,greatlyreducingtheirholdingpower.•
This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.•
This product was designed to be installed on the following surfaces only:•
CEILING CONSTRUCTION HARDWARE
Concrete Included
Wood joist Included
Other surfaces See Accessories or contact Peerless
Tools Needed for Assembly
Drill•
10 mm (3/8”) masonry drill bit for concrete•
5mm (7/32") drill bit for wood joist•
11mm (7/16”) socket wrench for wood screw•
13mm socket wrench for M8 lock nut•
Studnder("edge-to-edge"studnderisrecommended)•
M5
M4
M6
Multi-washer (4)
Parts List Qty
AM8 x 65mm security socket button head screw 2
B8mm split lock washer 1
CCathedral ceiling plate 1
D8mmatwasher 3
EM8serratedangedlocknut 1
F1.5m extension pole 1
GFlat panel mount box 1
HSupport collar 1
IM8 x 15mm security socket button head screw 2
JM5 x 10mm security socket button head screw 6
KTilt bracket 1
LM6 x 12mm security socket button head screw 4
MVertical adaptor bracket 2
NAdaptor bracket assembly 1
O8mm x 76mm wood screw 4
P10mm concrete anchor 4
QAdaptor bracket fastener pack 1
R4mm security Allen wrench 1
S5mm security Allen wrench 1
Accessories
MOD-AUB U-bolt Accessory for truss, pipe, Unistrut®, etc. 40-85mm.
B
A
C
D
E
F
G
I
H
K L
J
M
Adaptor bracket fastener pack (Q) contents:
M4 x 12mm
(4)
M4 x 25mm
(4)
M5 x 25mm
(4)
M5 x 12mm
(4)
M6 x 12mm
(4)
M6 x 30mm
(4)
M6 x 20mm
(4)
M6 x 25mm
(4)
0.5” spacer
(4)
0.75”
spacer (4)
M8 x 16mm
(6)
M8 x 40mm
(4)
M8 x 25mm
(4)
R
N
PO
S

Visit Peerless at www.peerless-av.co.uk
MOD-FPSKIT150 ISSUED 10-04-15 REV5
Page 3 of 4
For Technical Support call [phone]
Ceiling Plate Installation - Concrete Ceiling Plate Installation - Wood Joist
1. Drill 10mm x 76mm holes and insert
concrete anchors (P).
2. Place ceiling plate (C) over anchors (P)
and secure with screws (O).
3. Tighten all screws.
2
concrete
surface
1 3
Usingastudnder,locateandmarkthe1.
edges of the wood joist to be used in
mounting this product.
Use the ceiling plate (2. C) to mark the
centres of holes along the middle of the
joist.
Drill three 5mm x 76mm holes.3.
Attach ceiling plate (4. C) to ceiling using
three wood screws (O).
ABD
D
E
F
G
I
H
F
K
G
G
K
M
H
J
GK
F
F
P
C
O
C
O
C
J
K
M
L
N
1 2
4
3
56
Install in landscape or portrait orientation
Distance should be equidistant. Move
vertical adaptor brackets (M) to adjust.
Tighten all screws
Q
J

MOD-FPSKIT150 ISSUED 10-04-15 REV5For Technical Support call [phone]
Peerless-AV UK
Unit 3 Watford Interchange, Colonial Way,
Watford, Herts WD24 4WP, United Kingdom
Tel: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.peerless-av.co.uk
BBG Distribution Ltd, trading as Peerless-AV UK
Peerless-AV Europe
Unit 3 Watford Interchange, Colonial Way,
Watford, Herts WD24 4WP, United Kingdom
Tel: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.peerless-av.eu.com
BBG Distribution Ltd, trading as Peerless-AV Europe
Peerless Industries, Inc.
3215 W. North Avenue,
Melrose Park, IL 60160 USA
Tel (Toll Free): 1 800 865 2112
Tel: [phone]
Fax: [phone]
Web: www.peerlessmounts.com