Contact
PELA Tools
Solängsvägen 13
SE-513 70 Borås
Telefon: 033-202650
Environmental protection/
Scrapping
Recycle any unwanted material, do not
throw it in the household rubbish. All
machines, accessories and packaging
must be sorted and left at a recycling center and
disposed of in an environmentally friendly
manner.
Specifications
Load Capacity...............................................160 kg
Height..............................................700 to 800 mm
Save this manual
You will need the manual for the safety warnings
and precautions, assembly instructions,
operating and maintenance procedures, parts list
and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of
the front cover. Keep the manual and invoice in a
safe and dry place for future reference.
Safety and precautions
WARNING: Basic safety precautions should
always be followed when using the tool to reduce
the risk of personal injury and other damage.
Read all instructions before using this tool!
• Keep the work surface clean.
• Observe the conditions in the work area. Do
not use machines or power tools in damp or
wet locations. Do not expose to rain. Keep
the work area properly lit. Do not use power
tools in the presence of ammable gases or
liquids.
• Keep children away. Children should never
be allowed in the work area. Do not allow
them to handle machinery, tools or extension
cords.
• Store equipment that is not in use. When not
in use, tools should be stored in a dry place
to prevent them from rusting. Always lock up
tools and keep away from children.
• Do not force the tool. It will make the job
better and safer in the capacity it was
intended for. Do not use inappropriate
accessories in an attempt to exceed the tool’s
capabilities.
• Use the right tool for the job. Don’t try to
make a small tool or accessory do the job of
a larger industrial tool. Do not modify this tool
or use it for a purpose for which it was not
intended.
• Dress appropriately. Do not wear loose
clothing or jewelry, as they can get caught in
moving parts. Protective, electrically non-
conductive clothing and non-slip shoes are
recommended during work. Wear hair
protection to keep long hair out.
• Be alert. Watch what you’re doing and use
common sense. Do not use tools when you
are tired.
• Spare parts and accessories. Use only
identical spare parts when servicing. Using
other parts will void the warranty. Use only
accessories intended for use with this tool.
• Maintenance. For your safety, service and
maintenance should be done regularly by a
qualied technician.
WARNING: Warnings, precautions and
instructions in this user manual cannot cover
all possible conditions and situations that may
arise. The operator should understand that
common sense and caution are factors that
cannot be built into the product, but must come
from the operator itself.
Unpacking
When unpacking, check that the item is intact
and undamaged. If any parts are missing or
broken, please contact the seller.
Assembly
1. Attach the two Angle Brackets (2#) to the
Vertical Posts (3#) using Angle Adjustment
Handles (7#).See Figure 1.
2. Attach the two Vertical Post- Angle Bracket
assemblies from the previous step to the two
Support Legs (4# & 5#) using four Bolts (13#),
Washers (14#) and Locknuts (15#).
3. Attach the Support Brace (12#) to the Vertical
Posts (3#) using two Bolts (13#), Washers
(14#) and Locknuts (15#). See Figure 2.
