Pet Gear EASY STEP IV PG9740 User manual

To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
For The ON-THE-GO Pet™
INSTRUCTION MANUAL
EASY STEP IV
PG9740

EASY STEP IV • PG9740
2
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service.
Dowels
Risers
Top Stair
with Straight Edge with Curved Side
Left Panel Right Panel
AB
C
E
D
Middle and
Bottom Stairs
F

EASY STEP IV • PG9740 3
ASSEMBLY INSTRUCTIONS
Step 1
With rubber grippers on the bottom, place right
panel, part (B) on oor with PET GEAR Logo
facing the oor and insert top stair, part (E).
Keep the STRAIGHT EDGE toward the back and
rug facing the top. Make sure there are no gaps
between parts after inserted. (If inserting part
is difcult put a little dish soap on doweled end
before inserting.)
Step 2
Insert riser, part (C).
Make sure there are no gaps between parts
after inserting.
Step 3
Insert second stair, part (F). Note the CURVED
SIDE direction. Make sure there are no gaps
between parts after inserting.
Step 4
Insert riser, part (C). Make sure there are no
gaps between parts after inserting.
C
B
E
Straight Edge
Make sure
rubber
grippers
are on the
bottom.
F
B
C
Curved
Side

EASY STEP IV • PG9740
4
ASSEMBLY INSTRUCTIONS
Step 5
Insert third stair, part (F). Note the CURVED SIDE
direction. Make sure there are no gaps between parts
after inserting.
Step 6
Insert riser, part (C). Make sure there are no gaps
between parts after inserting.
Step 7
Insert bottom stair, part (F). Note the CURVED SIDE
direction. Make sure there are no gaps between parts
after inserting.
F
Curved
Side
F
C
F
Curved
Side

5
EASY STEP IV • PG9740
ASSEMBLY INSTRUCTIONS
Step 8
Insert the nal riser, part (C). Make sure there are no gaps
between parts after inserting.
Step 9
Insert dowels, part (D). Make sure there are no gaps between
parts after inserting.
Step 10
Attach left panel, part (A). Align all holes before pushing
panel down. Make sure there are no gaps between parts
after inserting.
F
C
D
D
D
A

EASY STEP IV • PG9740
6
WARNING!
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw
aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive,
destructive, immature or untrained animals. Do not use near an open or exposed ame. Failure to follow these
warnings and the instructions could result in serious injury or death.
REPLACEMENT PARTS
Use only PET GEAR replacement parts.
Please have your model number ready before calling.
You can also request parts: http://www.petgearinc.com/main.asp?sel=2
192 Sheldon Avenue • West Rutland, VT 05777 • 877-752-9123 • www.petgearinc.com