Philadelphia Scientific Stealth Watering System FLT-DC12 User manual

Stealth Watering System™
DC Watering Cart
(FLT-DC12)

Installation:
1. The unit is shipped in one carton and is completely assembled.
The battery charger is the only part not attached to the cart.
2. Federal Regulations require battery-powered equipment to be
shipped with the battery disconnected. Before using the cart,
connect the battery: Open the back cover of the cart. Locate
the red and black wires with Quick-Connect connectors. Plug
the male connector into the female connector and close the
back cover. Warning: Battery posts, terminals and related
accessories contain lead and lead compounds. Wash hands
after handling.
Charging the Battery:
1. Only the charger unit provided should be used to charge the
battery. Any other charger may cause overcharging which will
cause permanent battery damage.
2. The battery needs only 10 hours to fully charge. To charge the
battery, plug into any indoor 120-volt grounded socket. Ground
fault interrupter circuits are recommended. To prevent electric
shock, do not charge outdoors or in wet areas. Unplug the
charger after an overnight charge. The charger will not damage
the battery if left connected for longer periods; see the charger
manual for important safety instructions.
A weak battery will cause low water pressure
and the Stealth Valves may not shut off properly.
This water supply is not for use with Philadelphia
Scientific®Water Injectors™
NOTE

Operation Instructions:
1. Remove the black cap and fill tank with deionized water. Replace
the black cap when full.
2. Turn the power switch to the ON position. The switch is located on
the back of the cart. The pump will come on for a few
seconds and switch off by itself.
3. Attach the output hose on the watering cart to the Quick-Connect
on the Stealth Watering System™. Filling will begin as soon as
they are connected.
3. Once the spinner stops and all the yellow indicators on each float
are visible, the battery filling is complete.
4. Disconnect the Quick-Connect to stop flow.
5. Continue to the next battery. Repeat as needed.
6. Turn off cart when the watering of batteries is complete.
7. Charge the battery as needed. The battery only needs 10 hours to
fully charge; see the charger manual for important safety instructions.
Replacement
Parts
CRT-040
Pump
CRT-095
Battery
ACC-066
Replacement
Back Panel
CRT-149
Charger
FLT-071
Output Assembly
with Flow
Indicator

DOC0267
Rev 08/2017
Philadelphia Scientific LLC 207 Progress Drive Montgomeryville, PA 18936
P: 215.616.0390 F: 215.616.0500 www.phlsci.com
© 2017 Philadelphia Scientific LLC. All Rights Reserved. Philadelphia Scientific and the
PS logo are registered trademarks of Philadelphia Scientific. Stealth Watering System and
Water Injedctor System are trademarks of Philadelphia Scientific LLC. E&O.E.
HEALTH AND SAFETY PRECAUTIONS
Batteries contain sulphuric acid, always wear approved protective
clothing (gloves, goggles and apron).
VRLA Battery 12 VDC 7.5Ah/20 Hour
Used in DC Powered Watering Cart
Battery replacement part number CRT-095.
WARNING:Battery posts, terminals and related accessories contain
lead and lead compounds.
Wash hands after handling.