Philco GH609 User manual

INSTALLATION
Positioning
650mm
top of cooking
surface
Fixing dimensions
WARNING!
these instructions may result in electrical hazards.
900
500
56
538
320
290
Min 745/Max 1030

● Mark the location for flue cover wall mounting brackets, rangehood
mounting points and anti-tilt fixing points above the rangehood
using the base as the reference point (Fig. 1).
Drilling holes
250 mm
23.5 mm
250 mm
250 mm
Upper chimney extension
bracket attachment points
Chimney bracket
attachment points
Upper hood
attachment points
Lower hood
attachment points
580 mm
36 mm
286 mm
559 mm
Fig.1
●Attach the upper hood mounting screws in the locations shown
in Fig.2. Use the ST 4x32 mm screws and expansion plugs if
attaching to masonry.
Attach chimney brackets and hood mounting screws

● Remove the aluminium filters from the rangehood body and hang
it on the mounting screws then secure at the anti-tilt locations as
indicated in Fig. 3.
Attached hood on wall
2mm
Fig.2
Fig.3

●Connect Ø150mm ducting adapter to the blower outlet and use
screws ST 4x12mm to fix it to the range hood (Fig. 4).
Connect ducting adapter
Fig.4
Ø150mm
Ducting adapter
Ø150 to Ø125mm
adapter
●If necessory, connect the Ø150 to Ø125mm adapter to the
Ø150mm ducting adapter (Fig. 4).
Important! For best performance, Ø150mm ducting is
recommended (Ø125mm ducting can be used, but will reduce
the airflow of the cooker hood).
●If need exhaust air to the outside.
Connect Ø150 mm or Ø125 mm
flexible duct to the adapter and
fix it (Fig. 5).
Fixing flexible duct
Fig.5

Attach the chimney
●Fix the chimney to the top bracket
using two screws ST 4x12mm.
Connect top of the ducting tube to
vent kit as per manufacturers
Connect ducting adapter
Fig.6
Fig.7
●Install back the aluminium filters to
rangehood, and remove the
protection film from rangehood and
chimney.
instructions (Fig. 7).

ST 4x32 螺絲和膨脹膠塞。

ØST
Ø
Ø

安裝煙囪
連接煙囪
圖6
圖
將煙囪固定在頂部支架上，用 螺絲
安裝及固定。 將排氣管的頂部連接
到支架上（圖 ）。
將金屬隔油網裝回抽油煙機上，並
將其保護膜取下。
ST 4x12
毫米