Philips Sonicare AirFloss Installation guide

FAQ
AirFloss Original
When on the charger, the charge indicator flashes green to indicate that the appliance is charging.
Note: When the charge indicator flashes yellow, the battery is low and needs to be recharged
(fewer than 3 uses left).
How long does a full charge last?
When it is fully charged, AirFloss has an operating time of up to 2 weeks (or 14 uses).
AirFloss Ultra with triple burst
When the handle of your AirFloss is on the charger, you will see the following lights on the
handle (also shown in the image below):
1 solid green LED = 33% charged.
2 solid green LEDS = 66% charged.
3 solid green LEDS = 100% charged.
Note: When it is fully charged, your AirFloss Pro/Ultra has an operating time of up to 11 days
when it is used in single burst mode. When the charge indicators of your AirFloss flash yellow,
this means that the battery is low and you have less than 3 uses left. In this case, please charge
your AirFloss.

How to clean my Philips Sonicare AirFloss
To clean your Philips Sonicare AirFloss, follow the instructions below.
Note: Do not clean your AirFloss in the dishwasher or any other sanitising devices.
Cleaning the handle and nozzle
Follow these easy step-by-step instructions on how to clean the handle and nozzle:
1. Remove the nozzle from the handle
2. Rinse the inside and outside of the nozzle after each use to eliminate any residue
3. Open the reservoir and rinse it with warm water
4. Wipe the entire surface of the handle with a damp cloth
If your Philips Sonicare AirFloss handle or nozzle becomes clogged, use the following steps to
unclog:
1. Fill the reservoir with warm water
2. With the nozzle attached, press the activation button until the reservoir is completely
empty
Cleaning the charger
To clean the AirFloss charger, follow the steps below:
1. Uplug your charger from the wall socket
2. Wipe the entire surface of the charger with a damp cloth

How do I use my Philips Sonicare AirFloss?
Our Philips Sonicare AirFloss uses compressed air to accelerate micro-droplets of water (or
mouthwash) between teeth. To use our AirFloss, follow the instructions below.
Using Philips Sonicare AirFloss
To use our AirFloss, follow our step-by-step instructions:
1. Turn on your AirFloss by pressing the power button
2. Place the nozzle tip between your two teeth at the gum line. Slightly close your lips over
the nozzle to avoid any splashing
3. Press the activation button to deliver 1-3 bursts of air and micro-droplets of
water/mouthwash between the teeth
4. Slide the nozzle tip along the gum line until you feel it settle between the next two teeth
5. Continue this process for all spaces between your teeth, including behind your back teeth
6. Turn off your AirFloss once done
Note: Your AirFloss will automatically turn off if it has not been used for one minute.
AirFloss burst modes
You can change the burst modes to have the desired amounts each time you press the activation
button. To change the modes, press the power button continuously until you reach your desired
mode. The LEDs show the selected mode:
•Single burst: 1 LED
•Double burst: 2 LEDs
•Triple burst: 3 LEDs

Note: For optimal results, use the triple burst mode (default setting) from both the outside and
inside of your teeth.