Installation guide/
Ϊܞڲ
1Connect / டઅ
These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment.
If you have any questions regarding installation kits, consult your Philips car audio dealer.
ԒܞሬכȹঁΪyЎܰwΣؿӁӹτɺؿұwᇼ൬ϷྦྷᎶؿሁኬyΣྦྷΪɮԮ˳τЄဘw
ᇼݡ Philips Ӂӹࠑᚊሻy
This unit is designed for negative ground (earth) 12 V DC operation only.
Always install this unit in the car dashboard. Other locations can be dangerous as the rear of the unit heats up during
use.
To avoid short-circuit: before you connect, ensure that the ignition is off.
e that you connect the yellow and red power supply leads after all other leads are connected.
e that all loose leads are insulated with electrical tape.
e that the leads do not get caught under screws orin parts that will move (e.g. seat rail).
e that all ground (earth) leads are run to a common ground (earth) point.
dware for a safe and secure installation.
oper fuses can cause damage or fire.When you need to change the fuse, consult a professional.
ϊສஉ߮ඩሬכ߲รઅΔ 12 V DC ኧАy
ᇼ৻ສΪכӁӹშٲɻyߗΪכԯˢϽສ˿ι፮wΐݯԚ༦ೡɻສ߇ࠍผೕᆅy
ݯᑷЛˮଊ༏}ᇼᆢցΕடᇃɾکᗐஶᒨˌᗐy
ᆢցடઅֺτʵᇃ܃wʹடઅඡϳϳཋʵᇃy
ᆢցֺτᕌౙʵᇃɰԚᇂᇒᇂy
ᆢցʵᇃᙨᓳΕᑓֶଫ৽ཌྷɐΣ౯አy
ᆢցֺτઅΔʵᇃޑடઅԷஃઅΔဲy
ඩࠉԚ፭ڃؿ൬ϷΪw˞ᆢړສӐ՞wΪͲಲ໒y
ɺሬؿړ፮ผኒߎଐۂՇฌֶʵˌӎyߗ߬ҡړ፮wᇼݡพɁɡy
Caution / ؇෮
Note on the power supply lead (yellow)
When you connect other devices to this apparatus, ensure that the rating of the car circuit is higher than the total fuse
value of all the connected devices.
Notes on speaker connection
ever connect speaker wires to the metal body or chassis of the car.
ever connect speaker wires with stripes to one another.
ཋʵᇃඡϳ؇෮ԑඖ
ԯˢສடઅԷϊӡࣂwᇼᆢցӁӹཋ༏ؿ˲ଅঢ়כֺτɰடઅສؿړ፮ᅕࠤᐢy
ᐰኂடઅ؇෮ԑඖ
ᇼʜᐰኂᇃடઅϭټᙔֶӁӹ֛ᆚy
ᇼʜᐰኂᇃྦྷઅy
ke sure that all bare wires are insulated with electrical tape.
ᆢցֺτᕌౙʵᇃɰԚᇂᇒᇂy
As different cars have different requirements, yently from the user
manual’s instructions. In that case, consult a professional mechanic to connect.
כɺؿӹሤτɺؿұw˿ผ߬˞ɺכԚʹ˫ܞؿʿβԞடઅy
Σ༤ϊѼwᇼݡพҌ൬Ϸடઅy
ௐഽ
Caution / ؇෮
This car audio video system allows you to connect to the rear view backup camera. You can view the things that happens
behind your car in the display,especially you are driving a big vehicle.This helps protecting your bumper and anything it might
contact.
Ӂӹᄧࠑӡ˿Ԝடᇃϭ܃഼ႤХᙘᄧዀy˿˞Εᛷኂɻ݅ޜӹ܃ԑذwПܰቝቛɣێӹሤࣂy
ΣϊτХכړᙶړ፮઼ʥԯ˿અᘩԷؿЄྦྷോy
our local driving regulations on whether it is legally required to install the rear view backup camera.
These connections require a professional mechanic to install.
ᇼ݅Δቝቛؒஃw˞ᐃܰЯτΪ܃഼ႤХᙘᄧዀɾؒ܁ஃցyɐ߸டᇃพҌΪy
ௐഽ
Connect parking brake cable and reverse driving cable to a rear view backup camera
டઅʹ๗ӹᇃၤࠧӹᇃԷ܃഼ႤХᙘᄧዀ
1
2
3
4
5
a㩷㩷Illumination switch
b To the +12V car battery which is energized at all time
crelay control lead.Amplifier relay
control lead
d Ground
e Ignition keACC
f Antenna
g Subwoofer Out
h Aux-In
i Parking switch cable
j Reverse driving cable
k Video-In
l Camera-In
m Video-out 1 and 2
n Rear line-out
o Front line-out
a ๑עᗐ
டઅϭ +12V Ӂӹཋϑw፭ࣂ൬Ϸ˨ཋ
༠/ཋ৽ʨᇃᘗཋኂઁԹʵᇃy
ᒷɣዀᘗཋኂઁԹʵᇃ
અΔ
ᒨˌᗐ +12V DCw୮כرྸࣂ
ʨᇃ
ࠇГࠑ௬ፏˮ
Aux-In
ӹᗐᇃ
ࠧӹᇃ
഼ፏɃ
ᙘᄧዀፏɃ
഼ፏˮ 1 ၤ2
܃ʿᇃ༏ፏˮ
کʿᇃ༏ፏˮ
b
c
d
e
f
g
h
i
j
k
l
m
n
o
183mm 53.5mm
2ܼ
g Reconnect the negative terminal of the car battery.
ࠇณடઅӁӹཋϑؿ߲รy
For proper operation of the DVD player, the chassis must be mounted within 20 degree horizontal. e that the
unit is mounted within this limitation.
ݯᆢኧА DVD ᅌיዀw˞ˋ 20 ۹˞ʑؿӯ۹Ϊ֛yᇼᆢցສؿΪӯ۹˝ϊࠉࠤ˞ʑy
ௐഽ
eep the connection of the car battery if there is an on-board drive or navigation computer.Otherwise, the
computer may lost its memory.
To avoid short circuit, ensure the bare wires do not touch each other and disconnect the negative terminal of the car
battery.
ΣӁӹԮௐӹ༗ဤဥዀֶኒཋwᇼړܛӁӹཋϑؿடઅyЯڬ˿ኒߎཋ˾ɰΦؿ༅ࢿy
爲ȿᑷЛ༏ଊോwᇼᆢցႆᚉᇃɺผޚʃઅᘩwԎɻᒾၤӁӹཋϑ߲รؿடઅy
Caution / ؇෮
CED229/98
