Problem Possible solution
The appliance does not work. Put the mains plug in the wall socket and set the on/off switch on the
back of the appliance to ‘O’.
Make sure that the voltage indicated on the appliance corresponds to
the local mains voltage.
Fill the water reservoir with water.
coffee is too weak.
Make sure the number of cups you select with the 2-10 cups button is
consistent with the amount of water in the water reservoir. Please keep
in mind that the appliance uses all the water in the water reservoir.
Use the STRENGTH button to set the coffee strength to ‘strong’.
with.
When I use pre-ground
with the amount of water in the water reservoir. Please keep in mind
that the appliance uses all the water in the water reservoir.
coffee or decrease the amount of water.
I have set the coffee
strength to ‘strong’ with the
coffee is too weak.
strength with the STRENGTH button. In this case you can only increase
the coffee strength by increasing the amount of pre-ground coffee or
I remove the jug from the
appliance while it is brewing
coffee.
If you remove the jug for more than 20 seconds during the brewing
that the coffee does not reach its full taste before the end of the
brewing process.Therefore we advise you not to remove the jug and
pour out the coffee before the end of the brewing process.
The appliance continues to
drip long after the brewing
process has ended.
The dripping is caused by condensation of steam. It is completely
normal that the appliance drips for some time.
If you remove the jug for more than 20 seconds during the brewing
The coffee is not hot enough. Place the jug properly on the hotplate.
Make sure that the hotplate and the bottom of the jug are clean.
ENGLISH16