Philips HX2565/02 User manual

sensiflex

ENGLISH 4
FRANÇAIS 12
DEUTSCH 21
NEDERLANDS 29
ITALIANO 37
ESPAÑOL 45
PORTUGUÈS 54
3
HX2565

First use
1Put the plug in the wall socket.
C2Place the toothbrush in the charging unit.
The brush will now be charged automatically.
Let the appliance charge for at least 16 hours before
you use it for the first time.
C3Mount the brush head on the toothbrush by
inserting it into the bayonet catch and
turning it.
◗Put some toothpaste on the brush.
4Place the brush against your teeth and press
the on/off button.
C5Brush one tooth at a time,until you have
cleaned all teeth completely (minimum 2
minutes,see also the brushing instructions).
◗As a result of the Gum Protection System,you will
hear and feel the brush flexing backwards when
too much pressure is applied.
C6After use,always clean the inside and the
outside of the brush head as well as the
toothbrush itself.
◗You can put the toothbrush back in the charging
unit after use.
For more information on how to use the appliance,
read the section‘instructions for use’.
12
4ENGLISH

ENGLISH 5
Important
◗Be sure to check if the wall socket to which you
connect the charging unit is live.In some
bathroom cabinets,the electricity supply to the
built-in socket may be interrupted as soon as the
light is switched off.
◗Charge the appliance for at least 16 hours before
you use it for the first time.
◗The mains cord of the charging unit cannot be
replaced.If the cord is damaged,the unit should
be discarded.Please apply to your Philips dealer or
to the Philips organisation in your country (refer
to theWorldWide Guarantee leaflet).
◗The built-in battery contains substances that can
be harmful to the environment.If you discard the
appliance in due course,remove the built-in
battery and hand it in at an official collection point
or dispose of it in accordance with the regulations.
See section‘Environmental aspects’.
◗If your appliance is marked with tthe following
text applies:
The built-in rechargeable (NiCd) battery
contains substances which may pollute the
environment.
When you discard your appliance in due course,
please ensure that the battery is kept separate
from normal household refuse and disposed of at
an officially assigned collection point.Please refer
to section‘Environmental aspects’.

6ENGLISH
Instructions for use
Mounting the appliance on the wall
C1Mount the charging unit to the wall.
◗Do not allow the charging unit to come into
contact with water.The toothbrush,however,is
watertight and can therefore be used safely
anywhere.
◗To mount the charger to the wall,you will need
2 wood screws (3,5 x 25 mm) and two wall
plugs (S5).They are available in any home centre.
Charging
C1Leave the appliance to charge for at least
16 hours before you use it for the first time.
◗The toothbrush can be put back in the charging
unit after use.
◗Only type HX2565: If the battery in the
toothbrush is being charged,the pilot light is green
and blinks.If the battery has been fully charged,
the pilot light burns continuously.
◗If the battery is almost empty,the pilot light is red
and blinks for 10 seconds after the toothbrush has
been switched off.
Tip:The toothbrush can be left to charge continuously.
When you start using the appliance,we recommend
you to use it until the battery is empty and do so three
times in a row.You can do this by using the appliance in
the normal way without recharging it between brushing
session until the motor almost stops running.To extend
16 hrs
1
2
21 mm

ENGLISH 7
the life time of the battery,reapeat this procedure
every six months.
How to use
C1Mount the brush head onto the toothbrush
by inserting it into the bayonet catch and
turning it.This will make it impossible for the
brush head to become detached due to
vibration.
C2Place the brush in your mouth.
C3Press the on/off button to switch the
toothbrush on.
C4The toothbrush will start rotating at the
highest speed.To switch to a lower speed,
press the 2-speeds button.
Brushing
C1Place the brush against the tooth at an angle,
in such a way that it covers the surface of the
tooth as well as the gum line.Hold the brush
in that position for a few seconds and then
move on to the next tooth.
12

◗The round brush head removes plaque from the
teeth and beneath the gum margin.
◗The individual moving ActiveTip cleans between
the teeth.
C2The brush will do the work for you.All you
have to do is guide the brush carefully along
the teeth and molars.
◗Make sure that you reach all surfaces of the teeth
(inside,outside and chewing surface) as well as the
gums properly.A fixed brushing pattern will
prevent you from skipping certain areas.
Safe brushing
C1The Gum Protection System will keep a
check on the pressure you exert on the
brush.
C2If you press the brush too hard against your
gums,you will feel and hear a click when the
brush head flexes backwards.As soon as you
reduce the pressure,the brush will return to
its normal position.
◗This will probably happen regularly when you first
start using the brush,but after some time you will
have discovered the optimal brushing pressure,
and the brush will flex backwards less often.
8ENGLISH

Tip: If plaque is removed properly,the gums will
have a pink colour and firmly surround the teeth.
Healthy gums do not bleed when you eat or brush
your teeth (see also the section‘taking optimal care
of your teeth’).
If,nevertheless,your gums bleed slightly the first few
times you use the brush,this bleeding will generally
stop after a few days.If it does not,consult your
dentist or dental hygienist.
Minimum brushing time: 2 minutes
◗In general,2 minutes will be enough to clean your
teeth properly.Therefore the brush is equipped
with a red pilot light that will blink for 40 seconds
when you have been brushing for 2 minutes.
◗Naturally,you can also brush longer than
2 minutes.
After brushing
C1Let the toothbrush run while you rinse the
brush head under the tap.Use lukewarm
water (max.60°C).
C2Also rinse the inside of the brush head.
ENGLISH 9

C3Switch the toothbrush on again to rinse
toothpaste residues from the drive shaft.
C4Store the brush head upside down in the
storage compartment,with the coloured ring
visible on top.
5You can clean the charging unit with a moist
cloth.
◗First unplug the charging unit!
Brush head replacement
C1Replace the brush head every three months
for the best brushing results.
◗The brush head should also be replaced when the
bristles start to bend outwards.
◗New brush heads are available from the shop in
which you have purchased your Philips Jordan
toothbrush.
Tip:Worn bristles will move plaque around rather
than remove it.They may also damage the gums.It is
therefore important that you replace the brush head
every three months.
CLICK
10 ENGLISH