Philips HP8107/00 User manual

Register your product and get support at
www.philips.com/welcome
EN User manual
Hairdryer
HP8107

a
b
c

English
Congratulations on your purchase, and welcome to Philips! To fully

www.philips.com/welcome.
1 Important
Read this user manual carefully before you use the appliance and
keep it for future reference.
 WARNING: Do not use this appliance near water.
 When the appliance is used in a bathroom, unplug it after use
since the proximity of water presents a risk, even when the
appliance is switched off.
 WARNING: Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
 Do not insert metal objects into the air grilles to
avoid electric shock.
 Never block the air grilles.
 Before you connect the appliance, ensure that the voltage
indicated on the appliance corresponds to the local power
voltage.
 Do not use the appliance for any other purpose than described
in this manual.
 
 When the appliance is connected to the power, never leave it
unattended.
 Always unplug the appliance after use.
 Never use any accessories or parts from other manufacturers

accessories or parts, your guarantee becomes invalid.
 Do not wind the mains cord round the appliance.

 If the mains cord is damaged, you must have it replaced by

persons in order to avoid a hazard.
 This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
 Children should be supervised to ensure that they do not play
with the appliance.
 For additional protection, we advise you to install a residual
current device (RCD) in the electrical circuit that supplies the
bathroom.This RCD must have a rated residual operating
current not higher than 30mA. Ask your installer for advice.
 If the appliance overheats, it switches off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they


This appliance complies with all standards regarding electromagnetic


evidence available today.
Environment
Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in at an

to preserve the environment.

2 Dry your hair
1Connect the plug to a power supply socket.
 For precise drying, attach the concentrator ( ) onto the
hairdryer.
 To disconnect the attachment, pull it off the hairdryer.
2  ) to 
for fast drying, 
hair,  to switch off.
After use:
1Switch off the appliance and unplug it.
2Place it on a heat-resistant surface until it cools down.
3Clean the appliance by damp cloth.
4Keep it in a safe and dry place, free of dust.You can also hang it
with the hanging loop ( ).
 
If you need information e.g. about replacement of an attachment or
if you have a problem, please visit the Philips website at www.philips.
com or contact the Philips Customer Care Centre in your country

there is no Consumer Care Centre in your country, go to your local
Philips dealer.

4 Troubleshooting
Problem Cause Solution
The appliance does
not work at all.
The power socket to
which the appliance
has been connected
may not live.
Ensure the socket is
live.
The appliance may
have overheated and
switched itself off.
Unplug the appliance
and let it cool down
for a few minutes.
Before you switch on
the appliance again,
check the grilles to
make sure they are

hair, etc.
The appliance may
not be suitable
for the voltage to
which it has been
connected.
Ensure that the
voltage indicated
on the type plate
of the appliance
corresponds to the
local power voltage.

© Royal Philips Electronics N.V. 2011
All rights reserved.

Trademarks are the property of Koninklijke Philips
Electronics N.V. or their respective owners.
3140 035 27702