IMPORTANT - Cleaning and maintenance
Smart Calc-Clean System
cleaning is done regularly.This helps to maintain a strong steam performance and avoids dirt and
Sound and light Calc-Clean reminder
-
to indicate that you have to perform the Calc-Clean process (Fig. 4).
-
Tip:You can continue to dry iron by not pressing the steam trigger.
Performing the Calc-Clean process with the Smart Calc-Clean container
Do not leave the appliance unattended during the Calc-Clean process.
1 Fill up the water tank halfway (Fig. 6).
2 Make sure that the appliance is plugged in and switched ON during the Calc-Clean
process (Fig. 7).
3 Turn the temperature dial to CALC CLEAN (Fig. 8).
4 Place the Smart Calc-Clean container on the ironing board or any other even, stable
surface (Fig. 9).
5 Place the iron stably on the Smart Calc-Clean container.
6 Press and hold the Calc-Clean button for 2 seconds until you hear short beeps (Fig. 10).
7 During the Calc-Clean process, you hear short beeps and a pumping sound.Wait
approximately 2 minutes for the appliance to complete the process (Fig. 11).
8 When the Calc-Clean process is completed, the iron stops beeping (Fig. 12).
Caution: During the Calc-Clean process, hot water and steam ( approx. 50°C) come out of the
soleplate.
Note:The handle may get wet due to steam.This is normal.
9 Wipe the iron with a piece of cloth and put it back on the base station (Fig. 13).
10 As the Smart Calc-Clean container becomes hot during the Calc-Clean process, wait approx.
5 minutes before you touch it.
11 Carry the Smart Calc-Clean container to the sink, empty it and store it for future
use (Fig. 14).
7
