SAFETY INSTRUCTIONS -PART B - E N G L I S H -
•
The
manufacturer advises
the
correct
use
of
Luminaires (lightingfixtures)!
Therefore
always
follow
these instructions
to
ensure
correct
and safe installation and functioning
of
the
luminaire and keep
it
for
future
reference.
•
Turn
off
electrical
power
at
main fuse
or
circuit
breaker
box
before
commencing installation,
maintenance
or
repair.
•
If
in
doubt,
consult
a qualified electrician
or
contact
your
retail
outlet.
Ensure
that
you
always install
the
luminiare
to
the
local electrical code.
Certain
regulations indicate
that
luminaires should
be
installed
by
a qualified electrician.
•
Observe
the
correct
color
of
the
wiring
before
installation:
white
(N),
black (L) and green
or
bare
copper
wire
(Ground).
•
Do
not
connect
this luminaire
to
a non-grounded electrical
system.WARNING:
Installing
this
fixture
in
a non-grounded electrical system
could
allow
metal
parts
of
the
luminaire
to
carry
electrical
current
if
any
wires
or
wire
connections become
broken
or
loose.
Under
this
condition,
anyone coming in
contact
with
the
luminaire is subject
to
electric
shock
which
could
cause
injury
or
death.
•Always use
wire
nuts/connectors
rated
for
the
correct
gauge and
number
of
wires
used.
CAUTION:
Be
certain
that
no
bare
wire
strands
are
exposed
outside
of
the
wire
nuts/connections
(if
applicable).
•
Be
careful
not
to
damage
or
cut
the
wire
insulation (covering)
during
installation.
Do
not
permit
wires
to
contact
any sharp edges.
•
Do
not
remove
thermal
insulation pad(s).
Doing
so
will
result
in
increased
temperatures
and possible
risk
of
fire.
• Maintain
interior
lighting
with
a
dry
cloth
duster,
do
not
use abrasives
or
solvents.Avoid liquid
on
all
electrical parts.
• Always consider all
the
technical specifications
of
the
luminaire.Verify
the
stated icons
on
the
identification label
on
the
luminaire and
the
icons
that
are
shown
in
part
A
of
your
safety instructions.
ATTENTION: Belowyou will find all the explanations with numeric reference to the icons respec-
tively in front
of
these PART-B safety instructions. Applicable icons toyourfixture are shown in
PART-Asafetyinstructions.
01-
This luminaire should
only
be
installed indoors.
02-
The
luminaire is suitable
for
outdoor
usage.
03-
Only
suitable
for
dry
locations.
04-
Suitable
for
damp locations.
OS-
Suitable
for
wet
locations.
06-
Luminaire
is
suitable
for
base
up
mounting.
07-
Luminaire is suitable
for
base
down
mounting.
08-
Luminaire issuitable
for
horizontal mounting.
09-
The
luminaire
is
only
suitable
for
fixing
to
the
ceiling.
I
0-
The
luminaire
is
only
suitable
for
fixing
to
the
wall.
I
1-
The
luminaire
is
suitable
for
fixing
to
the
wall and
to
the
ceiling.
12- Always observe the minimum distancebetween
the
lamp and
the
surface being
lit
as
indicated
on
the
icon.
13- Free
air
space
of
at
least 4 inches
must
be
kept
between
top
of
shade and
bottom
of
canopy.
14- Immediately replace a cracked
or
broken
safetyglass and use
only
manufacturer approved parts.
15-
Strip
the
wire
as
indicated
in
the
diagram.
16-
Use
heat-resistantcable
for
wiring
the
luminaire
into
the
mains.
17-
MAX
....
W:only
use lamps suitable
for
this luminaireand keep
within
the
maximum
specified wattage.
18-
This
product
is
not
suitable
for
children
under
14
years
19-
The
Luminaire has a
ground
conductor
identified
with
green insulation
or
bare
copper
wire
..
20-
The
luminaire
is
only
suitable
for
a lamp
with
built-in safety
or
a
low
pressure lamp.An
extra
safety
glass
is
not
necessary.
21-
Capsule and linear halogen lamps may
not
be
touched
by
bare hands.
22-
The
luminaire
is
equipped
with
afuse.
If
the
luminaire
is
out
of
order
aker
the
bulb
has been replaced,
the
internal fuse
has
to
be
replaced.
If
contact
with
the
internal
wiring
can
be
made
during
this
opera-
tion,
this should
be
done
by
a
competent
electrician.
23-
The
luminaire can
be
used
with
a
dimming
circuit.
Consult
a qualified electrician
for
choosing
the
right
type
(especially
important
for
low
voltage luminaires).
24-
The
Luminaire
cannot
be
used
with
a
dimming
circuit.
25-
The
luminaire
is
dimmable
with
the
supplied
dimmer
ONLY.
Do
not
connect
to
an additional dimmer.
26-
The
dimmability
features depend
on
the
chosen lamp.
More
information
on
the
dimmability
features
is available
in
the
information
pack
provided
with
the
bulb.
27-
Luminaire
with
time
and lightsettingoptions.Minimum and maximum
will
be
shown in
the
icon in
partA
28-
The
luminaire can
be
placed
at
a
maximum
of
20k
height.
29-
To
reach an
optimal
working,
you
have
to
place
the
luminaire
on
the
height
mentioned
in
the
icon.The
maximum
and
minimum
reach
of
the
detector
is
also
mentioned
in
the
icon
in
partA
30-
The
standard active range
of
vision
of
the
detector
covers
the
given degrees
mentioned
in
the
icon.
31-
Ensure
that
you
don't
drill
through
electrical
wires
or
any
other
obstruction
in
the
wall
or
ceiling
during
installation!
32-This luminaire contains
in
some places
very
hot
parts.
33-
Product
to
be
installed
by
two
people.
34-
The
product
is
for
indoor
use
only.
Do
not
use in
wet
locations,
areas
directly exposed
to
water
or
outdoors.
35-
The
product
is
ZigBee certified. Zigbee
is
an
open standard
for
indoor
wireless communication.
All
Philips ZigBee
Certified productscan be connected
with
other
Philips ZigBee Certified products.
36- Bluetooth9 enabled product.
The
Bluetooth"
word
markand logos are registered trademarks owned by
Bluetooth
SIG,
Inc. and any use
of
such marks by
Signify
is
underlicense.
Other
trademarksand trade
names
are those
of
their
respective owners.
Signify
warrantsthat
this
device
will
be
free
from
defects
in
material
and
workmanship
and
will operate
for
2
years,
unless
a
different
period
is
stated
in
or
onthe
pacl<aging
ofthe
product,
based
onup
to
3hours
average
workingtime perdayfl
days
per
week,
when
used
as
directed. If
this
device
does
not
conform
to
the warranty,
Signify
will
send
you,
at
its
election,
areplacement
device
or
refund your
original
price upon receiptofthe returned
device,
register
receipt
and
proofof
purchase.
Please
call
our
toll-free
number,
1.aJ0-555-0050,
or
write
to
us
(address
indicated
onthe
pacl<aging)
to
find
out
how
to
rewm
the
device.
This
limitedwarranty does
not
cover
devices
subject
to
accident,
neglect,
abuse,
misuse
or
acts ofGod.
REPLACEMENT
OR
REFUND
IS
YOUR
SOLE
REMEDY.
EXCEPT
TO
THE EXTENTPROHIBITED
BY
APPLICABLE
LAW,
ANY
IMPLIED
WARRANTIES
ARE
LIMITED
IN
DURATION
TO
THEDURATION OFTHIS WARRANTY.UABIUTY FOR
INCIDENT
AL
OR
CONSEQUENTIALDAMAGES
IS
HEREBY
EXPRESSEL
Y EXCLUDED.
Some
states
and
provinces do
not
allow
exclusion
of
incidental
or
consequential
damages,
so
the
above
limitation
or
exdusion
may
not
apply
to
you. This warranty
gives
you
specific
legal
rights,
and
you
may
also
have
other rights
which
vary
from
state
to
state
and
province
to
province.
Philips
and
the
Philips
Shield
Emblem
are
registered
trademarks
of
Koninklijke
Philips
N.V.
Alterations
in
design
and
technical
specifications
reserved.
"Hue
Personal
Wireless
Lighting"
is
atrademark owned
by
Signify
Holding
B.
V.
■
