Philips PSA200 Quick start guide

PSA200 Firmware upgrade procedure
1. Download the zip file from the site. Then unzip the file into a temp folder on your
computer.
2. At Start->Programs->Nike->psa200, select and launch “Upgrader”.
3. When the user starts the Upgrader with no device connected, the following screen
is seen with the
Start button disabled.
• The
Start button is enabled only when the correct device is connected
• Click on the”…” button to browse and select the unzipped firmware file to be
loaded into the device and then click open
- Place a fresh battery to the set and connected to the PC
• The user is informed that the device will be upgraded with the new firmware.
On pressing OK, the firmware is loaded.
• Disconnect the device so that the device upgrades to the new firmware

-Press the play key and the LCD display shows :” FUpgrade”
-Wait until the set switch off automatically.
-The set is then upgraded.