Philips F-9308-750-0 User manual

PHILIPS UHP F-9308-750-0 (XL-2400) h ! ^ ^ /
Replacement Lamp for Sony® HD LCD Projection Television
User Instructions
CAUTION:
Do not attempt to remove the lamp immediately after use; doing so can cause serious burns. Prior to removing lamp, switch off
the power supply to the television and wait approximately 60 minutes or more to allow for complete lamp cooling.
Avoid touching the glass portion(s) of the lamp with bare hands; fingerprints, dirt and dust may cause early lamp failure and/or
image obscurity. It is recommended that gloves be worn when replacing the lamp.
When transporting the replacement lamp, use the box that is provided to avoid breakage.
WARNING:
• To avoid overheating and/or fire, ensure that the replacement lamp is mounted securely.
• Hg - LAMP contains MERCURY, Manage in Accord with Disposal Laws. See: www.lamprecycle.org or
1-877-977-0755. j
Replacing the Lamp
Switch off power to the television and wait about two minutes until the cooling fan stops. Unplug the power
cord from the wall outlet. Allow the television to cool for at least I hour.
Remove the lamp door. Turn the knob
counterclockwise to the OPEN position and pull out
the door.
Remove the lamp unit from the television by
hooking a finger through the loop of the lamp
handle and pulling it upwards; pull the lamp straight
out.
Note: To avoid injury, exercise caution when
removing the lamp unit and do not place your hand
in the lamp storage area.
PHILIPS
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF

a
Insert the new lamp unit, paying attention to the orientation and direction of insertion. Ensure that the new unit Is
mounted securely. If the lamp is not reattached securely, the self-diagnostic function may be triggered and the
POWER/STANDBY indicator will flash three times.
Note:To avoid shortened lamp life and/or reduced picture quality, do not touch the glass portion of the new lamp.
Reinstall the lamp door. Secure the door by turning
the knob clockwise back to the CLOSE position.
Replace the outside lamp cover. Plug the power cord
back into the wall outlet and turn on the power.
[Models KDF-42E2000 {US mode! only). KDF-
46E2000, KDF-50E2000 and KDF-55E2000; Select the
Lamp Replacement option (MENU > Settings > Setup
menu) and follow the on-screen procedure.]
3222 625 92041
Sony®is a registered trademark of Sony Corporation.
PHILIPS
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF