Philips BT7700 User manual

BT7700
Register your product and get support at
www.philips.com/support
User manual
Portable speaker

1EN
Contents
1 Important 1
Safety 1
Notice 1
2 Your Bluetooth speaker 3
Introduction 3
What's in the box 3
Overview of the speaker 4
3 Get started 5
Charge the built-in battery 5
Turn on/o 5
4 Use Bluetooth devices 7
Connect a Bluetooth device 7
Connect two Bluetooth devices
simultaneously 7
Play from Bluetooth device 8
Disconnect a device 8
Reconnect a device 8
Clear pairing information 8
Control your phone call 8
5 Other features 9
Listen to an external device 9
Charge your device 9
Adjust volume 10
6 Specications 11
7 Troubleshooting 12
General 12
About Bluetooth device 12

1EN
1 Important
Safety
Warning
•Never remove the casing of this speaker.
•Never place this speaker on other electrical
equipment.
•Keep this speaker away from direct
sunlight, naked ames or heat.
• Only use attachments or
accessories specied by the
manufacturer.
• The battery shall not be exposed
to excessive heat such as sunshine,
re or the like.
• Do not place any sources of
danger on the speaker (e.g. lighted
candles).
Note
• The type plate is located on the bottom
of the apparatus.
Notice
Any changes or modications made
to this device that are not expressly
approved by Gibson Innovations may
void the user’s authority to operate the
equipment.
Compliance
Hereby, Gibson Innovations declares that
this product is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC. You
can nd the Declaration of Conformity on
www.philips.com/support.
Care of the environment
Disposal of your old product and
battery
Your product is designed and
manufactured with high quality
materials and components, which can
be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU.
This symbol means that the product
contains a built-in rechargeable
battery covered by European Directive
2013/56/EU which cannot be disposed
of with normal household waste. We
strongly advise you to take your product
to an ocial collection point or a Philips
service centre to have a professional
remove the rechargeable battery.

2EN
Inform yourself about the local separate
collection system for electrical and
electronic products and rechargeable
batteries. Follow local rules and
never dispose of the product and
rechargeable batteries with normal
household waste. Correct disposal of
old products and rechargeable batteries
helps prevent negative consequences
for the environment and human health.
Caution
•Removal of the built-in battery invalidates
the warranty and may destroy the product.
Always bring your product to a
professional to remove the built-in battery.
Environmental information
All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buer) and polyethylene (bags,
protective foam sheet.)
Your system consists of materials
which can be recycled and reused if
disassembled by a specialized company.
Please observe the local regulations
regarding the disposal of packaging
materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos
are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such
marks by Gibson Innovations Limited
is under license. Other trademarks
and trade names are those of their
respective owners.

3EN
2 Your
Bluetooth
speaker
Congratulations on your purchase, and
welcome to Philips! To fully benet from
the support that Philips oers, register
your product at www.philips.com/
welcome.
Introduction
This speaker has passed splash-proof
test (IPX4) and can be used near water.
With this speaker, you can
• enjoy audio from Bluetooth-
enabled devices or other external
devices, and
• charge your external devices.
What's in the box
Check and identify the contents of your
package:
• Speaker
• USB cable for charging
• Printed materials
Quick Start Guide

4EN
Overview of the speaker
1
2
3
6
5
4
a /
• Enter Bluetooth pairing mode.
• After Bluetooth connection,
respond to an incoming call.
• Clear Bluetooth pairing
information.
b LED indicator
• Indicate battery or Bluetooth
connection status.
c Volume knob ( )
• Turn the speaker on or o.
• Adjust volume.
d AUDIO IN
• Connect an external audio
device.
e DC IN
• Charge the built-in battery.
f CHARGING (5 V 2.1 A)
• Charge your external device.

5EN
3 Get started
Always follow the instructions in this
chapter in sequence.
Charge the built-in
battery
The speaker is powered by the built-in
rechargeable battery.
Note
•It takes you approximately four hours to fully
charge the battery (use an 5V, 2.1A adaptor
as recommended). If your charging current is
below 2A, it may take more charging time.
•Rechargeable battery has a limited number
of charge cycles. Battery life and number of
charge cycles vary by use and settings.
•The LED indicator ashes red when the
battery is low.
To recharge the built-in battery:
• Connect the speaker to AC power
by using the adaptor (not supplied).
System
status
Battery status LED status
On Low power Flashing
red for 10
minutes, then
turn blue.
On Under
charging
Solid red for 5
seconds, then
turn blue
O Under
charging
Solid red
O Fully charged Turn o
Turn on/o
To turn the speaker on or o, rotate the
knob clockwise or anticlockwise until
you hear a click.
» When the speaker is turned on, the
blue LED indicator ashes.
» When the speaker is turned o, the
blue LED indicator lights o.
OFF
ON

6EN
Switch to standby mode
The speaker switches to standby mode
automatically when being idle for 15
minutes.
Note
•To wake up the speaker from standby
mode, press on the top of the speaker.

7EN
4 Use
Bluetooth
devices
With this speaker, you can listen to
audio from Bluetooth-enabled devices
and control the incoming call through
Bluetooth.
Connect a Bluetooth
device
Note
•Make sure that Bluetooth function is
enabled on your device, and your device is
set as visible to all other Bluetooth devices.
•Any obstacle between this speaker
and a Bluetooth device can reduce the
operational range.
•Keep away from any other electronic
device that may cause interference.
•The operational range between this
speaker and a Bluetooth device is
approximately 10 meters.
1 Turn on the speaker.
» The blue LED indicator ashes.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth
devices that can be paired (see the
user manual of the device).
3 Select [Philips BT7700] displayed
on your device for pairing. If
necessary, input “0000” as the
pairing password.
» After successful connection, the
speaker beeps twice, and the
LED indicator turns solid blue.
Connect two Bluetooth
devices simultaneously
You can pair and connect a maximum
of two Bluetooth-enabled devices to
the speaker at the same time.
• If the speaker is already connected
to one device, press and hold for
two seconds to enter pairing mode.
» The Bluetooth indicator ashes
blue quickly.
» The speaker is ready to pair with
a new Bluetooth device.
» The previous device is still
connected to the speaker.
• If the speaker is connected to two
devices at the same time and only
one device is playing audio, press
and hold for two seconds to enter
pairing mode.
» The idle device is disconnected.
» The speaker is ready to pair with
a new Bluetooth device.
• If the speaker is connected to
two devices at the same time and
neither of them is playing audio,
press and hold for two seconds to
enter pairing mode.
» The rst connected device is
disconnected.
» The speaker is ready to pair with
a new Bluetooth device.
LED indicator Description
Flashing blue
quickly
Ready for pairing
Flashing blue
slowly
Connecting
the previously
connected device
Solid blue Connected