Philips SBT30ORG/37 User manual

Register your product and get support at
www.philips.com/welcome
SBT30/37
User manual

a
b
c
f
de
g

BEEP
PHILIPS SBT30
B
EE
P

1 Important
Safety
Important Safety Instructions
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
h Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including ampliers) that
produce heat.
i Only use attachments/accessories specied by the manufacturer.
j Refer all servicing to qualied service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
k Apparatus shall not be exposed to dripping or splashing.
l Do not place any sources of danger on the apparatus (e.g. liquid
lled objects, lighted candles).

Warning
•Never remove the casing of this apparatus.
•Never lubricate any part of this apparatus.
•Never place this apparatus on other electrical equipment.
Notice
Any changes or modications made to this device that are not expressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.
Notice for the USA and Canada
This device complies with Part 15 of the FCC Rules and RSS standard
of Industry Canada. Operation is subject to the following two
conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules and ICES-003 of Industry Canada . These limits are designed
to provide reasonable protection against harmful interference in a
residential installation.This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Relocate the receiving antenna.

• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Radiation Exposure Statement: This equipment complies with
FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled
environment.The antenna(s) used for this transmitter must be installed
and operated to provide a separation distance of at least 20 cm from
all persons and must not be collocated or operating in conjunction
with any other antenna or transmitter. Installers must ensure that 20cm
separation distance will be maintained between the device (excluding its
handset) and users.
Disposal of your old product
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
Never dispose of your product with other household waste. Please
inform yourself about the local rules on the separate collection of
electrical and electronic products and batteries.The correct disposal of
these products helps prevent potentially negative consequences on the
environment and human health.
Your product contains batteries, which cannot be disposed of with
normal household waste. Please inform yourself about the local rules on
separate collection of batteries.The correct disposal of batteries helps
prevent potentially negative consequences on the environment and
human health.
Please visit www.recycle.philips.com for additional information on a
recycling center in your area.
Always bring your product to a professional to remove the built-in battery.
()
Environmental information

All unnecessary packaging has been omitted.We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
The making of unauthorized copies of copy-protected material, including
computer programs, les, broadcasts and sound recordings, may be
an infringement of copyrights and constitute a criminal offence.This
equipment should not be used for such purposes.
Note
•The type plate is located on the bottom of the apparatus.
2 Your Bluetooth Speaker
Congratulations on your purchase, and welcome to Philips! To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
Introduction
With this speaker, you can enjoy audio from the compatible Bluetooth
device or your PC/ Mac.

3 Get started
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number
of this apparatus.The model number and serial number are on the
bottom of the apparatus.Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Power supply
The speaker can operate on built-in rechargeable battery.
To recharge the built-in battery:
Connect micro USB socket( ) with PC through supplied USB cable.
» The power indicator( ) turns on.(white)
• The power indicator turns off when it’s fully charged.
The Carabiner
The carabiner( ) is used for easy carrying or hanging, not for climbing
support or fall protection.
4 Play
Play from a Bluetooth device
Note
•The effecitve operation range between the speaker and your Bluetooth
device is approximately 10 meters (30 feet).

1 Slide ( ) towards to select Bluetooth audio source.
» The Bluetooth indicator( ) ashes.(Blue)
2 Activate the Bluetooth function in your Bluetooth device.
3 Select “PHILIPS SBT30” on your Bluetooth device for pairing.
» The speaker beeps twice and the Bluetooth indicator( ) stays
steadily on.(Blue)
• For some devices, you may need to input “0000” as pairing
password.
4 Start music play on your Bluetooth device.
When there is an incoming call:
• Press Bluetooth button( ) to pick up the call.
• Press Bluetooth button( ) again to hang up the call.
Tip
•You can speak to the MIC( ) to get the best speakerphone
performance.
Play from an external device
1 Slide ( ) towards AUX to select Aux-in audio source.
» The power indicator( ) turns white.
2 Connect your speaker with an external device throught the supplied
USB cable.
3 Start music play on your device.

5 Product information
Note
•Product information is subject to change without prior notice.
Specications
Amplier
Rated Output Power 2W RMS
Signal to Noise Ratio >70dB
Aux-in Link 600 mV RMS, 10 kohm
Bluetooth
Bluetooth specication V2.1+EDR
Supported Proles HFPv1.6, AD2Pv1.2, HSPv1.2
Advanced features Echo and noise cancellations
Range 10 m/33 feet line of sight
General information
DC power input USB: 5V, 500mA;

Built-in Li-Polymer battery 3.7V 500mAH
Battery working time >8 hours
Dimensions-Main Unit
(diameter x height) D68mm * H81mm
Weight- Main Unit 0.14 kg
6 Troubleshooting
Warning
•Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/welcome).When
you contact Philips, ensure that the apparatus is nearby and the model
number and serial number are available.
No power
•Recharge your speaker.
No sound
•Adjust volume on your mobile phone or PC/Mac.
•Make sure that your Bluetooth mobile phone is within the
effective operation range.
•Check if you have selected the correct audio source.
No response from the speaker
•Restart the speaker.

All registered and unregistered trademarks are property of their
respective owners.
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
SBT30_37_UM_V1.0