Philips FC6094 User manual

FC6094, FC6092, FC6090

2

33
1

4

FC6094, FC6092, FC6090
ENGLISH 6
 14
 23
 31
 39
 47
 55
 64
 71
 79
 87
 95
 104
 112
 120
 128

6
General description (Fig. 1)
ABendable crevice tool (FC6092/6090)
BFloor nozzle (FC6094 only)
CCleaning brush
DCrevice tool
EBrush tool
FSocket for car cord (FC6092 only)
GContact points
HConnection for telescopic stick (FC6094 only)
ICharging light with battery-low indication
JExhaust air openings
KOn/off slide
LDust compartment release button
MMotor inlet grille
NFilter holder
O Innerlter
P Outerlter
QDust compartment
RNozzle release button
SNozzle insert
TDetachable nozzle
UNozzle & stick holder (FC6094 only)
VWall mounting bracket
WW. Charging base
XAdapter
YCar cord with car plug (FC6092 only)
ZTelescopic stick (FC6094 only)
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
Do not use the appliance if it is damaged in any way.Take it to an
authorised Philips service centre for repair.
,
,
ENGLISH

If the adapter or charging base is damaged, always have it replaced
by one of the original type to avoid a hazard.
FC6092 only: if the car cord or car plug is damaged, stop using the
car cord and have it replaced by one of the original type.
Never suck up water or any other liquid. Never suck up ashes until
they are cold.
Never immerse the vacuum cleaner, the adapter or the charging
base in water.
Remove the adapter from the wall socket before cleaning the
charging base.
Only charge the vacuum cleaner with the adapter and charging
base supplied. During charging, the adapter will feel warm to the
touch.This is normal.
Always switch the vacuum cleaner off after use.
Keep the appliance out of the reach of children.
The voltage on the contact points in the charging base is low (max.
30 volts) and therefore not dangerous.
Never block the exhaust air openings during vacuuming.
Switch the appliance off when recharging it.
To avoid the risk of electric shock, be careful when drilling holes in
the wall to attach the wall mounting bracket, especially close to a
wall socket.
Always use the appliance with the lter unit.
Always use the appliance with the nozzle insert in place.
Noise levels:
FC6090: Lc = 78 dB [A]
FC6092: Lc = 79 dB [A]
FC6094: Lc = 80 dB [A]
Preparing for use

1 Screw the wall mounting bracket to the wall with the screws
supplied with the appliance. (Fig. 2)
2 Attach the charging base to the wall mounting bracket. (Fig. 3)
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
-
-
-
ENGLISH 7

3 Attach the nozzle & stick holder to the wall mounting bracket
(FC6094 only).
4 Screw the nozzle & stick holder to the wall with the screws
supplied with the appliance.
5 You can also place the charging base on a level and horizontal
surface. (Fig. 4)
6 Slide the brush tool onto the crevice tool and place them in the
charging base. (Fig. 5)
7 FC6094 only: insert the telescopic stick and the oor nozzle into
the nozzle & stick holder (‘click’). (Fig. 6)

Chargetheapplianceforatleast18hoursbeforeyouuseitfortherst
time.
When the charging light starts blinking during operation, the battery pack
is running low and needs to be recharged.
1 Insert the small plug into the charging base and insert the adapter
into the wall socket. (Fig. 7)
The charging light will go on to indicate that the appliance is
charging. (Fig. 8)
Note:The charging light will stay on as long as the appliance is placed on the
charging base and the adapter is in the wall socket.
Note:The charging light does not give any information about the charge level
of the built-in battery pack.

1 Push the on/off slide forwards to switch the appliance on. (Fig. 9)
2 Push the on/off slide backwards to switch the appliance off.
(Fig. 10)
,
ENGLISH8

3 Leave the adapter in the wall socket and always put the vacuum
cleaner back onto the charging base after use, even if the battery
pack is still almost fully charged.


This appliance comes with the following tools:
1. brush tool for cleaning delicate surfaces
2. crevice tool for cleaning hard-to-reach places
3. bendable crevice tool for cleaning at an angle (FC6092/6090 only)
1 Take the tool you want to use.
2 Attach the tool to the detachable nozzle. (Fig. 11)
Car cord (FC6092 only)
With the car cord you can connect the vacuum cleaner to the cigarette
lighter socket in your car and use it as long as necessary without having to
recharge it.
1 Insert the small plug of the car cord in the socket of the appliance
and insert the car plug in the cigarette lighter socket of your car.
(Fig. 12)
The car cord cannot be used to charge the appliance.
2 Detach the car cord from the appliance by pressing the button on
the small plug.
To prevent damage, do not pull the small plug out of the appliance
without pressing the button.

1 Attach the telescopic stick by pushing it rmly into the back of the
appliance until it locks into position (‘click’). (Fig. 13)
Thetelescopicstickgivesyouextrareachwhencleaninghardoors,
carpets and hard-to-reach areas.
2 Then attach the oor nozzle to the detachable nozzle. (Fig. 14)
Theoornozzlecanbeusedtovacuumhardoorsandcarpets.
-
-
-
ENGLISH 9

Theoornozzleisequippedwithauffcollectorthatremoveshairor
uff.
Note:Pass the uff collector gently over the hairs or uff to be removed. The
hairs or uff will be worked loose from the surface, collected and then sucked
up.
3 Adjust the stick to the length you nd most comfortable during
vacuum cleaning by pushing the ring downwards and pulling the
upper part of the stick upwards. (Fig. 15)
4 To detach the telescopic stick, press the release button on the
back of the vacuum cleaner and pull the stick out of the appliance.
(Fig. 16)
Cleaning
Always remove the adapter from the wall socket before cleaning the
charging base.
Never immerse the vacuum cleaner, the adapter or the charging base in
water.
1 Clean the charging base and the appliance with a damp cloth.

Makesureyouemptythedustcompartmentandcleanthelters
regularly.
Weadviseyoutocleantheltersevery2to4weekstomaintainoptimal
suction performance.
Quick cleaning
Toquicklyemptythedustcompartment:
1 Remove the detachable nozzle by pressing the nozzle release
button. (Fig. 17)
2 Shake the contents of the dust compartment out into a dustbin.
(Fig. 18)
ENGLISH10