Philips HR8571/18 User manual

Mobilo Plus

2

3
6
12
17
14 16
18
6
7
19 20
4
11
9
13*
10
1
2
12
8
15
3
5*

4

ENGLISH 6
POLSKI 11
ROMÂNĂ 16
РУССКИЙ 21
ČESKY 26
MAGYAR 31
SLOVENSKY 36
УКРАЇНСЬКІЙ 41
HRVATSKI 46
EESTI 51
LATVISKI 55
LIETUVIŠKAI 59
SLOVENŠČINA 63
БЪЛГАРСКИ 68
SRPSKI 73
Mobilo Plus
5

Keep page 3 and 78 open when reading these instructions for use.
Environment
◗To make recycling possible,the plastics used for this appliance have been coded.
◗The cardboard packaging has been made of recycled material and is fully recyclable.
Important
Read these instructions for use carefully before using the appliance and save them for future
reference.
◗Make sure the dustbag has been placed correctly before using the vacuum cleaner for the
first time.
◗Never use the vacuum cleaner to suck up water or any other liquid.Never suck up
flammable substances and do not suck up ashes until they are cold.
◗When the vacuum cleaner is used to suck up fine dust,the pores of the dustbag may become
clogged,causing the passage of air through the dustbag to become obstructed.As a result,the
dustbag-full indicator will indicate that the dustbag needs to be replaced,even though the
dustbag is not full at all.
◗Never use the vacuum cleaner without the Motor Protection Filter.This could damage the
motor and shorten the life of the appliance.
◗Only use:
- Philips s-bag`double-layer paper dustbags (type FC8021);
- Sydney+ double-layer paper dustbags (type HR6999 Sydney+);
- or the cotton dustbag provided (some types only).
◗If the mains cord or another part of this appliance is damaged,it may only be replaced by
Philips or a service centre authorised by Philips,as special tools and/or parts are required
and in order to avoid hazardous situations.
◗Noise level:Lc = 77,5 dB(A)
BPlease note that * in the figure numbers means that this figure applies to specific types only.
Connecting and disconnecting accessories
Hose
1To connect the hose,insert it into the opening in the vacuum cleaner (fig.1).
2Turn the hose clockwise (fig.2).
3To disconnect the hose,turn it anticlockwise (fig.3).
Tube
1To connect the tube to the handgrip and to connect the nozzle to the tube,insert the
narrow section into the wide section while turning a little (fig.4).
Telescopic tube (specific types only)
1To adjust the telescopic tube to the required length,grasp the plastic ring and pull the upper
tube upwards as far as necessary.Lock the telescopic tube in position by releasing the plastic
ring (fig.5).
ENGLISH6

Nozzles
Convertible nozzle
◗With the brush strip folded in,the convertible nozzle can be used on carpets (fig.6).
◗With the brush strip folded out,the convertible nozzle can be used on hard floors (fig.7).
Crevice tool,small nozzle and small brush
◗These accessories can be found in the special storage compartment (fig.8).
◗Small nozzle (fig.9).
◗Crevice tool (fig.10).
◗Small brush (fig.11).
Using the appliance
Adjusting suction power
1You can adjust the suction power by means of the slide on the handgrip (fig.12).
2You can also adjust the suction power by turning the knob on the vacuum cleaner to the
desired setting (fig.13).
- Set the knob to MAX for maximum suction power.
- Set the knob to MIN for minimal suction power.
Insufficient suction power
Please make sure that:
- the knob on the vacuum cleaner is in the right position;
- the slide on the handgrip is closed;
- the dustbag is not full;
- the nozzle,tube or hose is not blocked up.
To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible) in
reverse position.Switch the vacuum cleaner on to make the airflow suck the obstructing material
out of the blocked-up item.
Parking the tube
1Insert the tube clip into the parking slot (fig.14).
2This allows you to park the tube in a convenient position in a single movement (fig.15).
Storage
1Switch the vacuum cleaner off.
2Remove the mains plug from the wall socket.
3Rewind the mains cord by pressing the cord winder button.
4Put the appliance in upright position and attach the lower tube to the vacuum cleaner by
inserting the tube clip in the slot (fig.16).
5You can slide the clip along the tube to adjust its height (fig.17).
ENGLISH 7

Replacing the dustbag
◗Replace the dustbag as soon as the dustbag-full indicator has turned red permanently,i.e.
even when the nozzle is not placed on the floor (fig.18).
1Switch the vacuum cleaner off.
2Open the cover (fig.19).
3Push the dustbag holder backwards (fig.20).
4Remove the full dustbag by pulling the cardboard tag (fig.21).
When you do this,the dustbag is sealed automatically.
5Slide the cardboard tag of the new dustbag into the two grooves of the dustbag holder as far
as possible (fig.22).
6Pull the dustbag holder forwards.You will hear a click (fig.23).
BYou cannot close the cover if no dustbag has been inserted.
BPhilips s-bag`double-layer paper dustbags are available under type number FC8021.
Cotton dustbag
◗If provided,you can use the cotton dustbag instead of paper dustbags.The cotton dustbag can
be used and emptied repeatedly.To insert and remove the cotton dustbag,simply follow the
instructions for replacing paper dustbags.
To empty the cotton dustbag:
1Hold the dustbag over a dustbin.
2Remove the clip by sliding it off the dustbag sideways (fig.24).
3Shake out the contents (fig.25).
4Close the dustbag by sliding the clip back onto the bottom edge of the dustbag (fig.26).
BWhen using the cotton dustbag we advise you to wash the Motor Protection Filter once a year
in lukewarm water.Make sure the filter is completely dry before reinserting it into the vacuum
cleaner.
Motor Protection Filter
◗This appliance is equipped with a greatly improved,triple-layer permanent Motor Protection
Filter that guarantees optimal protection of the motor.This filter does not need to be
replaced.
BThis means that you can simply throw away the replacement filter supplied in each new box of
dustbags,since this filter is only required for older versions of this vacuum cleaner.
◗All you have to do is shake the permanent filter over a dustbag and reinsert it into the
vacuum cleaner every time you put in a new dustbag.
1Slide the filter holder out of the vacuum cleaner (fig.27).
2Remove the filter from the holder and shake it over a dustbin.
3Put the filter back into the holder as it was previously placed and press it firmly (fig.28).
4Push the holder with the clean filter firmly into place to ensure that it fits properly at the
bottom (fig.29).
ENGLISH8

Replacing theAFS Micro Filter.
◗TheAFS Micro Filter filters a large part of the smallest particles from the exhaust air by
means of its electrostatically charged fibres.
1Replace theAFS Micro Filter when you insert the first of a new set of dustbags.
2Place the bottom edge and the sides of the new filter properly behind the ridges of the
holder (fig.30).
3Make sure that the filter has been properly inserted before closing the holder (fig.31).
S-Class filter
◗Instead of with theAFS Micro Filter,some types are equipped with the revolutionary S-Class
Filter.This filter removes at least 99.97% of all particles down to 0.0003 mm in size from the
outlet air.
This not only includes normal house dust, but also harmful microscopic vermin such as house dust
mites and their excrements.
These are well-known causes of respiratory allergies.
BTo guarantee optimal filtering,the S-Class Filter must be replaced at least once a year.
BBoxes containing one S-Class Filter are available from you dealer under type number HR6992
or service number 4822 480 10084.
Replacing the S-Class Filter
1Pull the lever upwards to open the filter holder (fig.32).
2Remove the filter holder (fig.33).
3Remove the old filter and place the new S-Class Filter in the filter holder (fig.34).
4Place the filter holder back into the appliance by inserting the projections on the bottom
edge into the openings in the vacuum cleaner (fig.35).
5Push the filter holder back into place (fig.36).
6Fix the filter holder by pushing the lever downwards (fig.37).
Extra accessories
To enable you to profit even more from your Philips Mobilo Plus vacuum cleaner,several extra
accessories are available from your dealer.
Turbo nozzle (type number HR6988)
The turbo nozzle has been specially designed for deep-cleaning carpets and rugs.
The rotating brush effortlessly picks up small threads,hairs,fluff and other particles that are difficult
to vacuum.
Hard floor nozzle (type number HR6943)
This nozzle is especially suitable for cleaning large surfaces of parquet,tiles,etc.
If you have any difficulties obtaining dustbags,filters or other accessories for this appliance,please
contact the Philips Customer Care Centre in your country or consult the worldwide guarantee
leaflet.
ENGLISH 9

Guarantee & service
If you need information or if you have a problem, please visit the PhilipsWeb site at
www.philips.com or contact the Philips Customer Care Centre in your country (you will find its
phone number in the worldwide guarantee leaflet).If there is no Customer Care Centre in your
country,turn to your local Philips dealer or contact the Service Department of Philips Domestic
Appliances and Personal Care BV.
Philips 'Turbomax' motor
This vacuum cleaner is equipped with the very powerful Philips 'Turbomax' motor.
As long as the dustbag is more or less empty,medium suction power is quite enough for normal
use.This saves energy and makes vacuuming easier.
Increase the suction power as the dustbag becomes fuller.
This ensures that the dustbag is used to its full capacity.
ENGLISH10