Picberm PB2120 User manual

Instruction Manual
of
Picberm Masticating Juicer
PB2120
Printing Version: M
Rev
0
Soft
Hard

Contents
Chapter I. Precautions for Safe Operation----------------- 1
Chapter II. Parts and Functions----------------------------- 5
5
Chapter III. Method of Operation-------------------------- 6
Chapter IV. How to Assemble------------------------------ 7
7
Chapter V. Tips for Ingredient Selection------------------ 11
Chapter VI. Maintenance------------------------------------
Chapter VII. Trouble Shooting-----------------------------
14
Chapter VIII. Applicable Standard-------------------------
1
1

110-130V/ 60Hz

1
2
3
4
5
11
89
10
7
6
13
12
Rev
0
Soft
Hard

Switch Knob Operation:
“SOFT”: Appliance is ON, suitable for juicing soft fruit.
“HARD”: Appliance is ON, suitable for juicing hard fruit.
“O” : Appliance is OFF.
“REV” : Appliance will REVERSE auger. (use when
food is blocked or stuck.)
Tips:
1.In the case of pomace blockage or motor locking, twist
and hold the knob to“REV” for approximately 3 seconds
to rotate the auger in reverse and then release it. Twist
to “SOFT” or “HARD” to resume normal operation.
2.The motor will wait for 1.5 seconds before working
when switching between forward direction and reverse
direction.

Connect Drum ⑩with Housing ②:
Connect the drum ⑩with the housing ②by
aligning the “▼” on the feeding chute
with“ ” on the housing ②. Push the drum
hard and rotate the drum counter-clockwise
untilit aligns the “ ▼” on the feeding chute
⑧ with “ ” on the housing ②.(You will
hear “tick” sound and see the locking
button protrude to confirm you have
fastened it tightly and correctly.)
1
2
Place the auger ⑪into the drum ⑩.
3
Insert the juice strainer ⑫into the drum ⑩.
Chapter IV. How to Assemble

8
4
Place the end cap ⑬onto the drum ⑩end
and rotate the cap counter-clockwise.
5
Place juice container ⑤and the pomace
container ⑥under the drum set .
6
Place the pushing rod ⑦onto the cover
of feeding chute ⑧
7
Connect to power supply and get ready for
startup. (Before the power is on, make sure
the switch knob is in the off -position.)