Picberm PB2314 User manual

User Manual
of
Picberm Centrifugal Juicer
PB2314

Contents
Chapter I. Precautions for Safe Operation................ 1
Chapter II. Parts and Functions................................ 4
Chapter III. Method of Operation............................. 5
Chapter IV. How to Assemble.................................. 6
Chapter V. Tips for Ingredients Selection................. 9
Chapter VI. Maintenance and Preservation..............
Chapter VII. Trouble Shooting.................................
Chapter VIII. Applicable Standard...........................
12
14
17

1
Read the instructions below carefully before use.
Before using the juicer, please check whether the consistency is
between actual voltage with its rated voltage (110-130V～/60Hz).
Appliances can be used by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the appliance
in a safe way and if they understand the hazards involved. Children
shall not play with the appliance.
Warning: misuse may lead to potential injury. Care shall be taken
when disassembling the parts, handling the sharp cutting blades and
cleaning the juicer.
This appliance shall not be used by children. Please keep the
appliance and its cord out of reach of children.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a
hazard.
Always disconnect the appliance from the supply if it is left
unattended and before assembling, disassembling or cleaning.
This appliance is intended for household use and similar applications,
such as the following:
Chapter I. Precautions for Safe Operation
- staff kitchen areas in shops, offices and other working environments;
- farm houses;

2
- by clients in hotels, motels and other residential-type environments;
- breakfast-type environments.
Before power on, please ensure that the detachable parts, such as the
juicing sieve and are all in place and fully fastened;
if juicing sieve is damaged, please stop using the machine.
During operating, putting hand or sharp object into feed inlet is
strictly prohibited. Do not use any other things as pusher. Keep your
eyes away from the feed inlet in case of accidents.
During operating, do not touch parts such as juicing sieve and motor
wheel with operator's body or other hard foreign matters in case of
injury or damage to the juicer.
When using and completing juicing, please ensure that the motor
stops running and power is cut before removing its detachable parts.
All the hard pits or cores, hard stalk, large seeds, thick skin of the
fruits and vegetables should be removed before juicing.
It is strictly prohibited to sterilize all accessories with hot water
beyond 80℃or to microwave in case of thermal deformation and
damage.
Do not directly put the juicer body into water or flush it with water in
case of failure. Before wiping the juicer body, power must be
disconnected.
Do not clean the juicer with steel wool, abrasive cleaners or corrosive
liquid (e.g., gasoline, acetone).
transparent cover

3
Please operate it in strict accordance with rated working time: time of
continuous working shall not exceed 1 min; each cycle must be
stopped for 2 mins
mins
after completing functions; it must be stopped for
15-20 after continuously working 3 cycles, and then restarted
after motor has cooled. This method is helpful to extend its lifetime.
Non-professionals are not allowed to randomly remove its detachable
parts as it may cause electric shock; if the juicer fails, please send it to
a specified maintenance station for service.
Upon completion, please disconnect the power cord. If damaged, the
power cord must be replaced by a professional from the manufacturer,
its maintenance department or a similar department to prevent any
danger.
This juicer is for household use only. It is inadvisable to use it for
commercial purposes.
FOR FOOD CONTACT USE

4
No.
Part Name
Description and Function
1Pusher
When putting the ingredients in it, tenderly
pushes and presses the ingredients to ensure full
contact with juicing sieve so as to improve
juicing efficiency.
2Transparent
cover
Connects with the body. Exists as a major part of
the juicing process and serves as a safety
protection.
3Juicing sieve Cuts the ingredients with cutter on its bottom,
filters juice and separates pomace with side
sieve.
Chapter II. Parts and Functions

5
4Middle ring Gets and exports juice separated by juicing sieve.
5Handle Controls connection between transparent cover
and the body.
6
Pomace
container
Gets and collects pomace separated by juicing
sieve.
7Main body
Major part of the juicer, with internal motor and
other parts.
8
Juice
container
To hold and collect the juice extracted by the
juicer.
Before initial use of the juicer, please thoroughly clean the parts in contact
with the ingredients.
Rotary Switch Operation Overview
Position “0”: Close and shut off.
Position “I”: Low-speed gear, applied to
process soft fruits and vegetables, such as
orange, tomato, cucumber, strawberry.
Position “II”: High-speed gear, applied to
processing all fruits and vegetables.
Refer to “Tips for Ingredients Selection” for
detail instructions for selection of fruits and
vegetables.
Chapter III. Method of Operation

6
The juicer is designed with a double safety system and can start working
only after all parts are installed correctly.
Please install and use the juicer as follows:
1. Turn the body's switch into position
“0” , put the pomace container in place and
install the middle ring into the body.
2. Put the juicing sieve into the middle ring
and ensure that the juicing sieve is
installed correctly on the motor wheel.
(Check the completeness of juicing sieve
before use; if damaged, do not use it).
3. Put the transparent cover into the body
from the right above and install it in the
direction indicated on the transparent
cover.
4. Put and press the handle to two lugs on
the transparent cover. It is correctly
installed with a cluttering sound, or the
juicer will not work.
Chapter IV. How to Assemble

7
6. Put the juice container under the juice
outlet.
7. Connect power source and prepare for
startup. The working time shall be ≤1 min.
(Before connecting power, please ensure
the switch is off.)
8. Clean, peel (shell) and pit fruits and
vegetables, then cut them into pieces of
suitable size for feed inlet.
9. Before putting food inside, start switch
and let the machine run no-load for 5 sec.
Select suitable tap position according to
type of fruits (refer to “Tips for Ingredients
Selection”). To extend the juicer's lifetime,
it is advisable to let it run continuously for
less than 1 min.

8
10. Put cut fruits and vegetables into
feed inlet on transparent cover, and
push it gently with the pusher. Do
not push or press the fruits and
vegetables with too much pressure
on the pusher, since this would affect
the quality of the end result.
a. If the pomace outlet is blocked or the
pomace container and juice container
is full after processing a period of
time, disconnect the power source and
clean them before use.
b. Do not put fingers or other objects
into feed inlet!
11. After ingredient processing is
completed, if no more juice come
out from the juice outlet, switch the
juicer off and disconnect the power
source. Then, wait until the motor and
juicing sieve has stopped rotating before
taking juice container away from the
juice outlet and turn the juice outlet
clockwise upward to prevent the juice
from dripping onto the counter top.
(Fresh fruit juice shall be drunk
immediately, since its taste and
nutritional value will be affected if
exposed to air for a while.)