Picberm PB2210 User manual
User Manual
of
Picberm Masticating Juicer
PB2210
Contents
Chapter I. Precautions for Safe Operation................1
Chapter II. Parts and Functions.................................4
Chapter III. Method of Operation.............................6
Chapter IV. How to Assemble...................................7
Chapter V. Tips for ingredients Selection.................10
Chapter VI. Maintenance and Preservation..............12
Chapter VII. Trouble Shooting.................................13
Chapter VIII. Applicable Standard...........................15
Read the instructions below carefully before use.
Before using the Juicer, please check the consistency between actual
voltage with its rated voltage (110-130V～/60Hz).
Appliances can be used by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the appliance
in a safe way and if they understand the hazards involved.
Children shall not play with the appliance.
This appliance shall not be used by children. Keep the appliance and
its cord out of reach of children.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a
hazard.
Always disconnect the appliance from the supply if it is left
unattended and before assembling, disassembling or cleaning.
This appliance is intended for household use and similar applications,
such as the following:
- staff kitchen areas in shops, offices and other working
environments;
- farm houses;
- by clients in hotels, motels and other residential-type environments;
- breakfast-type environments.
1
Chapter I. Precautions for Safe Operation
Before power on, please ensure that detachable parts, such as juicing
sieve and top cap, are put in place and fully fastened; if juicing sieve
is damaged, please stop using the Juicer.
During operating, do not put hand or sharp object into feeding inlet. It
is strictly prohibited to use any other thing as a pushing rod. Keep
your eyes away from the feeding inlet in case of accidents.
During operating, do not touch parts such as juicing sieve and motor
wheel with operator’s body or other hard foreign matters in case of
injury or damage to the Juicer.
When using and completing juicing, please ensure that the motor
stops running and power is cut before removing its detachable parts.
Fruits and vegetables shall have pits, hard seeds, thick skin or hard
cores removed before processing.
It is strictly prohibited to sterilize all accessories with hot water
beyond 80℃ or to microwave in case of thermal deformation and
damage.
Do not directly put the Juicer main body into water or flush it with
water in case of failure. Before wiping the Juicer body, power must be
disconnected.
Do not clean the Juicer with steel wool, abrasive cleaners or corrosive
liquid (e.g., gasoline, acetone).
2
Non-professionals are not allowed to randomly remove its detachable
parts as it may cause electric shock; if the Juicer fails, please send it to
a specified maintenance station for service or contact us.
Upon completion, please disconnect the power cord. If damaged, the
power cord must be replaced by a professional from the manufacturer,
maintenance department or a similar department to prevent any
danger.
This Juicer is for household use only. It is inadvisable to use it for
commercial purposes.
FOR FOOD CONTACT USE
3
No.
Name of
Parts
Function Introduction
1
Pomace
container
Contain and gather pomace separated from
juicing body.
2
Juice
container
Contain and gather juice separated from juicing
body.
3 Control panel
Control working conditions of this product,
including starting up, powering off, reverse
rotation.( it reversely rotates a while only after
turned off), hard fruits and vegetables, soft fruits
and vegetables.
4
Chapter II. Parts and Functions
10
9
8
7
6
1
23
5
4
13
11
12
4 Power cord
It is used to connect power supply and provide
working power.
5 Main body
This is the major part of this machine and
contains the motor that is the power producer and
provides working power.
6 Juicing body
Store ingredientss and produce juice and pomace
through juice outlet and pomace outlet.
7 Juicing sieve
Run with the spiral propeller, grind up
ingredientss and filter juice.
8
Spiral
propeller
Hand over and grind up ingredientss through
running with Juicing sieve.
9 Top cap
Connect with the juicing body, playing a safety
protection role.
10 pushing rod
Help to push ingredientss to juicing body for
juicing
11 Safety cover
Prevent hands or hard objects from reaching the
working area when the machine is working;Open
it to feeding ingredientss in.
12 Lock catch of
safety cover
Sliding to the left or right can make safety cover
open or close up. Safety cover is close up when
initial received.
13 Juice outlet
lid
Prevent dripping.The lid of juice outlet can be
removed. When opening the lid of juicing outlet,
juice in the juicing body can be extracted; when
the lid closes up, juice in the juicing body can be
temporarily sealed.
5
Before using this product for the first time, please thoroughly wash parts
that touch with ingredientss.
Instruction of buttons operation :
“On/off” button: starting up, power off and
reverse rotation.( it reversely rotates a while
only after turned off)
“1” button: slow rotation speed and indicator
light shows 1, this gear is used for soft fruits
and vegetables, e.g., cherry tomato.
“2” button: high rotation speed and
indicator light shows 2.This gear is used for
hard fruits and vegetables, e.g., carrot.
Note: In case of pomace discharging failure
or rotation blocked , the machine will make
sounds and shut down for one second, and
then reversely rotate for 4 seconds, and
finally power off.
(In the process of juicing, if necessary,
gently press “on/off” button, and the
indicator light shows “--”. Thereafter, the
machine will shut down for one second, and
then reversely rotate for 4 seconds, and
finally power off, and you can turn on and
continue juicing again.)
6
Chapter III. Method of Operation
1
2
ON/OFF
The Juicer is designed with a double safety system and can start working
only after all parts are installed correctly.
Please install and use the Juicer as follows:
1
Groove on the juicing body is aligned with
convexity on the Main body. Place the
juicing body on the Main body.
2
Pomace outlet on the juicing sieve
(compound net) is aligned with the pomace
outlet on the juicing body.Place the juicing
sieve into the juicing body.
(Please make sure that the red sealing
gum is inserted into the groove of
pomace outlet completely)
3
The spiral propeller is inserted into the
center of juicing sieve.Press the spiral
propeller with a decent strength to make the
spiral propeller properly inserted into the
base hole.
7
Chapter IV. How to Assemble
4
“” on the Top cap is aligned with
“” on the juicing body, spin the top cap
along with the juicing body. When a sound
is heard, this indicates a good snap-fit.
Contrary procedures are carried out for
detaching the top cap from the juicing
body.
5
Respectively put the juice container and
pomace container under the juicing outlet
and pomace outlet.
6
Connect power source and prepare for
startup. (Before connecting power, please
ensure the switch is off.)
7
Clean and remove the core, hard seeds,
thick skin or hard shell from fruits and
vegetables.
8
8
Press “on/off” button on the control panel,
then select “1” or “2” button. The juicer
will continuously work for 20 minutes.
9
Put ingredientss into the feeding inlet on
the top cap and push them with the pushing
rod.
Feed larger ingredientss through the larger
feeding inlet (e.g., apples/snow pear, etc.),
and feed others especially the long one
through the smaller feeding inlet (e.g.,
celery/cherry tomato/grapes, etc.).
Do not use too much force to push
ingredientss.
(Do not put hand or sharp object into
feed inlet)
10
After all ingredientss being processed
completely and no juice/pomace come out
any more, turn off the switch, waiting for 5
seconds and disconnect the power supply.
(Fresh juice shall be drunk immediately,
since its taste and nutritional value will
be affected if exposed to air for a while.)
9
1. Use fresh fruits and vegetables, since they contain more fluid. Specific
preferred fruits are the following: pineapple, beetroot, celery stick, apple,
cucumber, carrot, spinach, melons, tomato, mandarin orange, grape, etc.
2. It is unnecessary to remove thin peels and skins. Only thick peels (e.g.,
those of oranges, pineapples or beetroots) need to be removed. Seeds (e.g.,
those of oranges) shall also be removed.
3. When extracting apples, the fruit density depends on the variety of
selected apple. For apples with more fluid, the fruit will be denser. Thus,
you can select the apple variety according to your requirements on fruit
density.
4. As fresh apple juice will quickly turn brown, you can add a few drops of
lemon juice to slow down this discoloring process.
5. Leaves and stems (e.g., lettuce) could be extracted in the Juicer for
juice.
6. It is inadvisable to put fruits containing starch, such as banana, pawpaw,
avocado, fig, and mango, into the Juicer for juice extraction.
The typical nutrient ingredient contained in fruits/vegetables are shown
below:
10
Fruit/Vegetable
Vitamin/Mineral
kcal
Apple
Vitamin C
200 gram = 150 kJ (36 kcal)
Apricot Dietary fiber and potassium
30 gram = 85 kJ
（
20 kcal
）
Beet
Folic acid, dietary fiber,
Vitamin Cand potassium
160 gram = 190 kJ(45 kcal)
Blueberry Vitamin C
125 gram = 295 kJ(70 kcal)
Chapter V. Tips for
ingredients
s Selection
11
Brussels Sprouts
Vitamins C, B, B6 and E, folic
acid
and dietary fiber
100 g
ram = 110 kJ(26 kcal)
Cabbage
Vitamin C, folic acid,
potassium,Vitamin B6 and
dietary fiber
100 gram = 110 kJ(26 kcal)
Carrot Vitamins A, C and B6, and
dietary fiber 100 gram=110 kJ (26 kcal)
Celery Vitamin C and potassium 80 gram = 55 kJ(13 kcal)
Cucumber
Vitamin C
280 gram = 120 kJ(29 kcal)
Fennel Vitamin C and dietary fiber
300 gram = 145 kJ(35 kcal)
Grape
Vitamins C and B6, and
potassium
125 gram = 355 kJ(85 kcal)
Carambola Vitamin C and potassium
100 gram = 100 kJ(24 kcal)
Muskmelon Vitamins C and A, folic acid
and dietary fiber
200 gram = 210 kJ(50 kcal)
Nectarine
Vitamins C and B3, potassium
and
dietary fiber
180 gram = 355 kJ(85 kcal)
Peach
Vitamins C and B3, potassium
and
dietary fiber
150 gram = 205 kJ(49 kcal)
Pear
Dietary fiber
150 gram = 250 kJ(60 kcal)
1. Put the Juicer in a dry and ventilated place for long-term storage to
prevent the motor from being affected by damp air, which threatens
appliance safety.
2. It is easy and convenient to clean the Juicer immediately after use. It is
strictly prohibited to directly put the body in water or flush it with water.
Power must be disconnected before wiping the body with a dry cloth.
Parts other than the body can be washed in water.
3. Do not wash the detachable parts with water hotter than 80℃, or
sterilize it in a high temperature disinfection cabinet. It is proper to add
cleaner into the warm water and clean it with a cleaning brush, then, rinse
it with clean water.
4. Clean detachable parts in accordance with the following steps:
1Spin the top cap along with the
juicing body and detach it.
12
Pineapple Vitamin C
150 gram = 245 kJ(59 kcal)
Raspberry
Vitamin C, iron, potassium
and magnesium
125gram= 130kJ(31kcal
）
Chapter VI. Maintenance and Preservation
2
All parts (
①
according to the contrary direction
to installation.
3Juice outlet lid can be freely
detached or installed.
4
If there are pomaces stay in
pomace outlet, withdraw the
sealing gum from the pomace
outlet groove and rinse it with
water, then insert it back to the
groove
Common failure Cause analysis Solution
After power
connecting,
switch it on and
the Juicer doesn’t
work.
1.Center ring was not
installed in place.
2. Top cap was not
installed in place.
3. Microswitch is broken.
1. Put the center ring in
place.
2. Put the top cap in
place.
3. Replace top cap.
4. Put all parts in place.
13
Chapter VII.
Trouble Shooting
1
2
3
4
Motor gives out
disguising smell
during the first
few times of use
Normal phenomenon
If the smell remains
after using for several
times, please contact us
via email.
Stop during
operation
1. The voltage is below
level.
2. ingredientss are
excessive.
3. Exert excessive
pressure to press the
pushing rod.
4. When the motor is
overheating, the motor
will have protection.
1. Check if the voltage
is too low.
2. Disconnect power
source and take
redundant ingredientss
out.
3. Lightly press the
pushing rod.
4.Switch it off for 20-30
minutes before use it
again.
Fruit contains
much pomace
1. Juicing sieve is broken.
2. Too much pomace
accumulated in the center
ring.
1. Replace the broken
juicing sieve.
2. Replace the center
ring.
Only a little fruit
juice comes out
1. Too much pomace
accumulated in the center
ring
2. Exerted large pressure
on the pushing rod.
1. Clean the center ring.
2. Lightly press the
pushing rod.
Obstructed cutter Cutter was twined by
ingredientss or deadly
locked.
Disconnect the power,
take ingredientss out
and cut them into
smaller pieces.
14
Abnormal
vibration or loud
noise
1. Juicing sieve was not
installed in an even
position.
2. The Juicier was not
placed smoothly and
steadily or its foot pad
came off.
3. Voltage is too high.
4. ingredientss are
excessive.
1. Put the juicing sieve
in place.
2. Put the Juicer
smoothly and steadily
in place or put the foot
pad in place.
3.Check if the voltage is
too high.
4. Disconnect the power
and take excessive
ingredientss out.
Note:
The above are analyses and resolutions of common faults. As for other
faults, please contact us via service email.Be sure not to take apart or
repair by yourself.
Model No.
PB2210
Rated Voltage
110-130V~
Rated Frequency
60Hz
Rated Power
200W
Continuous Operating Time
20 minutes
15
Chapter VIII. Applicable Standard
Table of contents
Other Picberm Juicer manuals
