Pickering 40-760 User manual

pickeringtest.com
Issue 2.1 June 2021
40-760/1A/2/3A/4/5A/6/7A User Manual
PXI 50Ω 600MHz RF Multiplexer Modules

Page (II) 50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
Page (II) REED RELAY MODULE 40-110/115/120/125
pickering
© COPYRIGHT (2021) PICKERING INTERFACES. ALL RIGHTS RESERVED.
No part of this publication may be reproduced, transmitted, transcribed, translated or stored in any form, or by
any means without the written permission of Pickering Interfaces.
Technical details contained within this publication are subject to change without notice.
ISO 9001
Reg No. FM38792

Page (III)
50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
Page (III)
REED RELAY MODULE 40-110/115/120/125
pickering
TECHNICAL SUPPORT
For Technical Support please contact Pickering Interfaces either by phone, the website or via e-mail.
WARRANTY
All products manufactured by Pickering Interfaces are warranted against defective materials and workmanship for a period of
three years, excluding programmable power supplies, from the date of delivery to the original purchaser. Any product found to be
defective within this period will, at the discretion of Pickering Interfaces be repaired or replaced.
Products serviced and repaired outside of the warranty period are warranted for ninety days.
Extended warranty and service are available. Please contact Pickering Interfaces by phone, the website or via e-mail.
ENVIRONMENTAL POLICY
Pickering Interfaces operates under an environmental management system similar to ISO 14001.
Pickering Interfaces strives to full all relevant environmental laws and regulations and reduce wastes and releases to the
environment. Pickering Interfaces aims to design and operate products in a way that protects the environment and the health and
safety of its employees, customers and the public. Pickering Interfaces endeavours to develop and manufacture products that can
be produced, distributed, used and recycled, or disposed of, in a safe and environmentally friendly manner.
Worldwide Technical Support and Product Information
pickeringtest.com
Germany
Tel: [phone]
E-mail: [email protected]
Sweden
Tel: [phone]
E-mail: [email protected]
USA
Tel: (West) [phone]
Tel: (East) [phone]
E-mail: [email protected]
Czech Republic
Tel: [phone]
E-mail: [email protected]
France
Tel [phone]
E-mail [email protected]
Pickering Interfaces Headquarters
Stephenson Road Clacton-on-Sea CO15 4NL United Kingdom
Tel: [phone]
E-Mail: [email protected]
China
Tel: [phone]
E-mail: [email protected]

Page (IV) 50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
Page (IV) REED RELAY MODULE 40-110/115/120/125
pickering
MEANING / DESCRIPTION SYMBOL
PROTECTIVE EARTH (GROUND)
To identify any terminal which is intended for connection to an external conductor for
protection against electric shock in case of a fault, or the terminal of a protective earth
(ground) electrode.
DANGEROUS VOLTAGE
To indicate hazards arising from dangerous voltages.
WARNING / CAUTION
An appropriate safety instruction should be followed or caution to a potential hazard
exists.
Refer to the relevant instructions detailed within the product manual.
HEAVY
If this product is heavy reference should be made to the safety instructions for
provisions of lifting and moving.
STATIC SENSITIVE
To indicate that static sensitive devices are present and handling precautions should
be followed.
!
kg
SAFETY SYMBOLS
PRODUCT SAFETY
The following safety symbols may be used on the product and throughout the product documentation.

Page (V)
50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
Copyright Statement ...................................................................II
Technical Support and Warranty................................................III
Product Safety .............................................................................IV
Contents (this page)....................................................................V
Warnings and Cautions ..............................................................VII
Section 1
Technical Specications.............................................................1.1
RF Performance Plots...........................................................1.6
Section 2
Technical Description .................................................................2.1
Functional Description..........................................................2.1
Relay Congurations ............................................................2.2
Section 3
Installation....................................................................................3.1
Pre Operation Checks...........................................................3.1
Hardware Installation ............................................................3.2
Software Installation .............................................................3.2
Testing Operation ..................................................................3.3
Section 4
Programming Guide....................................................................4.1
Programming Options For Pickering PXI Modules ............4.1
Programming The RF Multiplexer........................................4.2
Section 5
Connector Information................................................................5.1
Section 6
Trouble Shooting .........................................................................6.1
Section 7
Maintenance Information............................................................7.1
CONTENTS

Page (VI) 50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
THIS PAGE INTENTIONALLY BLANK

Page (VII)
50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
Page (VII)
REED RELAY MODULE 40-110/115/120/125
pickering
WARNINGS AND CAUTIONS
WARNING - HAZARDOUS ENVIRONMENTS SYMBOL
atmospheres. If the product is to be used in hazardous environments we recommend that the user
ensures suitable protective measures are taken.
!
WARNING - DANGER OF ELECTRIC SHOCK SYMBOL
This module may contain hazardous voltages. Before removing the module from the rack remove all
supplies and disconnect user I/O signals.
Unused slots in the host chassis are populated with blanking plates to prevent access to user
I/O signals that may be present. Blanking panels are available to order from Pickering in a variety
of slot widths. If the product is not used in this manner for example by using an extender card then
additional care must be taken to avoid contact with exposed signals.
CAUTION - HANDLING OF ELECTROSTATIC-SENSITIVE DEVICES SYMBOL
Certain semiconductor devices used in this equipment are liable to damage due to static voltage.
Observe the following precautions when handling these devices in their unterminated state, or
sub-assemblies containing these devices:
1. Persons removing sub-assemblies from equipment using these devices must be earthed by a
wrist strap and a resistor at the point provided on the equipment.
2. Soldering irons used during the repair operations must be low voltage types with earthed tips and
isolated from the mains voltage by a double insulated transformer.
3. Outer clothing worn must be unable to generate static charges.
4.
anti-static bags.
CAUTION - PRODUCT DOCUMENTATION SYMBOL
and understood before attempting to install or operate the product.
!
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
All cleaning and servicing requires the equipment to be isolated and disconnected from the power source and user I/O
signals (refer to the Maintenance Section).
• Appropriate manual handling procedures should be followed as dictated by the weight of the individual module or
the combined weight of the modules & chassis.
• Should a fault occur with the module or chassis, immediately isolate and disconnect the incoming power to the
chassis and the user I/O signals.
• Ensure the equipment is installed, operated and maintained by trained and authorised personnel.
• For suitably equipped products in the event of an emergency press the red “emergency stop” button situated on
the front of the unit.

Page (VIII) 50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
THIS PAGE INTENTIONALLY BLANK

Page 1.1
50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering SECTION 1 - TECHNICAL SPECIFICATION
SECTION 1 - TECHNICAL SPECIFICATION
pickeringtest.com
PXI 50 Ω 600 MHz RF Multiplexer 40-760/1A/2/3A/4/5A/6/7A
ISSUE 3.1 JUN 2021
yRange of 600 MHz RF Multiplexers
yAvailable as Dual, Quad & Octal SP4T,
Single, Dual & Quad SP8T,
Single & Dual SP16T or Single SP32T
yAll Versions Available With Automatic
Termination of Unused MUX Channels
ySMB Connectors
yVISA, IVI & Kernel Drivers Supplied for
Windows
ySupported by PXI or LXI Chassis
y3 Year Warranty
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
C
1
2
3
4
5
6
7
8
25
26
27
28
29
30
31
32
Channel Terminations
Common
Termination
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
C
1
2
3
4
5
6
7
8
25
26
27
28
29
30
31
32
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
C
Channel
Terminations
Common
Termination
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
C
1
2
3
4
5
6
7
8
C
Channel
Terminations
Common
Termination
1
2
3
4
5
6
7
8
C
1
2
3
4
C
Channel
Terminations
Common
Terminations
SP4T (2, 4 or 8 Banks) SP4T Terminated
(2, 4 or 8 Banks)
SP8T (1, 2 or 4 Banks) SP8T Terminated
(1, 2 or 4 Banks)
SP16T (1 or 2 Banks) SP16T Terminated
(1 or 2 Banks)
SP32T SP32T Terminated
1
2
3
4
C
off off
off off
off off
Bank 1
off
Bank 1
off
40-760 RF Multiplexer Range Overview
The 40-760 series is a range of 50 Ω RF multiplexers
available in SP4T, SP8T, SP16T and SP32T formats. All
multiplexers have the option of automatic termination
which offers the advantage of reducing standing waves
which can cause degradation in isolation and crosstalk.
All versions have low insertion loss and VSWR through
the use of modern RF relay technology at an affordable
cost. The multiplexers have been carefully designed
to ensure excellent and repeatable RF characteristics
to 600 MHz with each path having a nominally equal
insertion loss. The injection of noise and unwanted
signals into the signal paths has been minimized by
careful attention to the mechanical and electrical design.
The 40-760 range is supplied with drivers that allow
users to support the module in all popular PXI software
environments. In addition, the 40-760 range can be
supported in all Pickering’s LXI Modular Switching
chassis, allowing the use of a PXI or LAN controlled
switching solution with the same high levels of
performance.

Page 1.2 50Ω 600ΜHz RF MUX 40-760/761A/762/763A/764/765A/766/767A
pickering
SECTION 1 - TECHNICAL SPECIFICATION
600 MHz RF MUX, 40-760/1A/2/3A/4/5A/6/7A
pickeringtest.com
Specifications
RF Specification
RF Frequency Range: DC to 600 MHz
Impedance 50 Ω
Insertion Loss: Typically <0.5 dB to 100 MHz
Typically <3 dB to 600 MHz
VSWR: Typically <1.3:1 to 100 MHz
Typically <1.6:1 to 600 MHz
Isolation (all channels
off):
Terminated versions:
Typically >80 dB to 100 MHz
Typically >70 dB to 600 MHz
Unterminated versions:
Typically >75 dB to 100 MHz
Typically >50 dB to 600 MHz
Crosstalk: Typically <-60 dB to 100 MHz
Typically <-45 dB to 600 MHz
Maximum RF Power: 0.25 W* (terminated versions)
1 W (unterminated versions)
* Pulse capability up to 12 W / 650 ns pulse / cycle >32 µs
Power Requirements
+3.3 V +5 V +12 V -12 V
0.18 A 1.15 A 0 0
Operating/Storage Conditions
Operating Conditions
Operating Temperature:
Humidity:
Altitude:
0 °C to +55 °C
Up to 90 % non-condensing
5000 m
Storage and Transport Conditions
Storage Temperature:
Humidity:
Altitude:
-20 °C to +75 °C
Up to 90 % non-condensing
15000 m
PXI & CompactPCI Compliance
The module is compliant with the PXI Specification
2.2. Local Bus, Trigger Bus and Star Trigger are not
implemented.
Uses a 33 MHz 32-bit backplane interface.
Safety & CE Compliance
All modules are fully CE compliant and meet applicable
EU directives: Low-voltage safety EN61010-1:2010,
EMC Immunity EN61326-1:2013,
Emissions EN55011:2009+A1:2010.
Mechanical Characteristics
Single or dual slot 3U PXI (CompactPCI card).
3D models for all versions in a variety of popular file
formats are available on request.
Connectors
PXI bus via 32-bit P1/J1 backplane connector.
Signals via front panel SMB connectors as detailed in User
Manual.
Switching Specification (excluding terminations)
Switch Type: Electro-mechanical
Contact Type: Palladium-ruthenium,
Gold Covered Bifurcated
Maximum Switching Voltage: 30 VDC
Maximum Current: 1 A
Operate Time: 10 ms typical
Expected Life (operations)
Very low power load:
Low power load:
Full power load:
>1x108
>1.5x107 (0.1 A, 20 VDC)
>5x106 (1 A, 30 VDC)
RF Performance Plots
RF plots up to 1 GHz for all versions in the 40-760 range
are shown in the User Manual for:
• Insertion Loss
• VSWR
• Crosstalk