Safety Precautions
FCC Statement
This device complies with Part
15
of
the
FCC Rules.
Operation is subject
to
the
following
two
conditions:
(1)
This device
may
not
cause harmful interference.
(2)
This device
must
accept
any interference received,
including interference that
may
cause undesired operation.
Caution: Changes
or
modifications
not
expressly
approved
by
the party responsible for
compliance could void
the
user's authority
to
operate
the
equipment.
Federal Communications
Commission Interference Statement
This
equipment
has been tested and found
to
comply
with
the
limits for a Class B digital device, pursuant
to
Part
15
of
the
FCC Rules. These limits are designed
to
provide
reasonable protection against harmful interference in a
residential installation. This
equipment
generates uses and
can radiate radio frequency energy and, if
not
installed
and
used in
accordance
with
the
instructions,
may
cause
harmful interference
to
radio communications. However,
there is
no
guarantee
that
interference will
not
occur
in
a
particular installation. If this
equipment
does
cause harmful
interference
to
radio
or
television reception, which can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the
following measures:
(1)
Reorient
or
relocate
the
receiving antenna.
(2)
Increase
the
separation between
the
equipment
and
receiver.
(3)
Connect
the
equipment
into an outlet
on
a circuit
different from
that
to
which
the
receiver is connected.
(4)
Consult
the
dealer
or
an experienced radio!TV
technician for help.
RF Exposure Warning
This equipment
must
be
installed and operated in
accordance
with provided instructions
and
the
antenna(s)
used for this transmitter
must
be
installed
to
provide a
2
separation distance
of
at
least
20
em
from all persons
and
must
not
be
co-located
or
operating in conjunction with
any
other
antenna
or
transmitter. End-users
and
installers
must
be
provide with antenna installation instructions
and
transmitter operating conditions
for
satisfying RF exposure
compliance.
Canada, Industry Canada (IC) Notices
This device complies with Industry
Canada
license-exempt
RSS standard(s).
(1)
this device
may
not
cause interference, and
(2)
this device
must
accept
any interference, including
interference
that
may
cause undesired operation
of
the
device.
Radio Frequency (RF) Exposure Information
The radiated
output
power
of
the
Wireless Device is
below
the
Industry
Canada
(IC)
radio frequency exposure limits.
The Wireless Device should
be
used
in
such a
manner
such
that
the
potential
for
human
contact
during normal
operation is minimized.
This device has also been evaluated
and
shown
compliant
with
the
IC RF Exposure limits
under
mobile exposure
conditions. (antennas are greater than
20cm
from a
person's body).
2.412-2.472GHz
Band
This device operates in
the
2.412-2.472GHz
range.
5.15-5.25GHz Band
This device operates in
the
5.150-5.250GHz
range.
Master Equipment:
The availability
of
some
specific channels and I
or
operational frequency
bands
are
country
dependent
and
are firmware
programmed
at
factory
to
match
the
intended
destination. The firmware setting is
not
accessible
by
the
end
user.
This device is Master equipment,
the
transmission
is disabled
in
the
5600-5650MHz
band.
