FLEETTM SERIES STATIC
Page 10 of 20
February 2023
DOOR PANEL /SLIDE LATCH INSTALLATION
Snap the Unisex Indicator Plate into the back of the Door Trim Panel.
Place the Door Trim Panel into the recess in the front of the door. While
holding the Door Trim Panel in position, place the Slide Latch and Slide
Latch Cover Plate on the inside of the door and line up the holes of
the Slide Latch Cover Plate, the Door, and the Door Trim Panel. Insert
(4) PC-000158 screws and tighten. NOTE: These screws should
be tightened to the point where they will interfere with
the sliding action of the Slide Latch and then backed off
slightly, leaving enough friction to prevent the Slide Latch
from sliding into the “In-Use/Open” position when the
door shuts. The U Shaped handle prevents persons from
inadvertently moving the slide latch to the “In-Use”
position when exiting the restroom. Insert the flip “Male-
Female” Indicator Plate into the slot on the top edge of the Door Trim
Panel (above where the Unisex Indicator Plate is located). Insert (2)
PC-000147 screws into the holes toward the hinged side of the door, line
up with the holes in the Door Trim Panel, and tighten. If the optional lock
is installed, unlock the lock by inserting the key into the lock and turning to
the left and back to the upright position which is the neutral or normal use position and
remove the key (this allows the Slide Latch to move into the “Open/In-Use” position
when persons are inside the restroom). Turn the key to the right and remove the key
for the locked position. Turning the key to the left indicates the open position and
the key can not be removed until either in the “Open/In-Use” or “Locked” positon.
IMPORTANT: The punched 1/4” hole in the center of the Slide Latch where
the “In-Use/Open” stamp is imprinted complies with code enabling the
door to be unlocked from outside the restroom in the event of distress and a
person inside were unable to unlock the door. A POINTED OBJECT INSERTED
INTO THE HOLE AND MOVING THE SLIDE LATCH TO THE LEFT WILL ALLOW
THE DOOR TO BE OPENED PROVIDING THE DOOR HAS NOT BEEN LOCKED
WITH THE KEY.
STEP 11:
Figure 1
PC-000158 Screw
(4) Used in this step
PC-000147 Screw
(2) Used in this step
ASSEMBLY INSTRUCTIONS
MIRROR INSTALLATION
Peel the protective cover from the front of the
mirror. Place the mirror in the recess in the door,
and fasten in place using the plastic push in
fasteners provided.
STEP 12:
PC-000367 - Push-In Fastener
(4) Used in this step
TOILET SEAT INSTALLATION
Place the toilet seat on the top of the tank. Line up the holes in the hinge of the seat with the holes in the top of the tank. Insert the seat bolts through
the hinges of the seat and through the seat base. Lift open the seat base, thread the plastic seat nuts on the ends of the bolts and tighten.
STEP 13:
