Populas VOX 6030 User manual

HARDWARE BAG WITH:
H (8) M8 Fastener
M(16) Clamps
ASSEMBLY INSTRUCTIONS
I (8) M6 Fasteners
L (6) #8 x 3/4” Fasteners
K (16) #6 x 1/2” Fasteners
N (4) Levelers (Or Optional Casters)
ASSEMBLY INSTRUCTIONS
D
E
PARTS INCLUDED:
LEG PACKAGE:
A (2) Telescoping
Legs
B(2) Feet
C (2) Support Brace
(1) Controller
(1) Control Switch
(1) Hardware bag
TABLE PACKAGE:
H (1) Table Top
TOOLS NEEDED:
Phillips Screwdriver
INFINITY
WORKSTATIONS, DESKS, AND TABLES WITH POWERED ADJUSTMENT
VOX 6030
Workstations, desks, and tables with powered adjustment
2720 West Idaho Street Boise, ID 83702 Toll Free 800-957-2720 Fax [phone] www.populasfurniture.com
ASSEMBLY INSTRUCTIONS
J(8) #10 x 1" Fasteners

STEP 2: SUPPORT BRACE
ATTACHMENT TO TELESCOPING
LEG
Position Support Brace (C) over Telescoping Leg (A)
as shown. Align the slot in the Support Brace (C) with
the cable exit and securely attach cable in cable cradle.
Secure Support Brace (C) to Telescoping Leg (A) with
four M6 Fasteners (I).
STEP 3: SUPPORT BRACE AND
CONTROLLER ATTACHMENT TO
TABLETOP
Position Support Brace (C) as shown with the cables facing
inward. Align with pre-drilled holes and attach Support
Brace (C) to Table Top (G) with four #10 x 1” Fasteners (J).
Position Controller (D) and Control Switch (E) as shown on
Table Top (G). Align with pre-drilled holes and attach
Control Switch (C) to table top as shown using four
# 8 x 3/4” Fasteners (L). Plug motor wire into Controller (D)
and secure cables to Table Top (G) with Clamps (M) and
#6 x 1/2” Fasteners (K). Plug each cable from the
Telescoping Legs (A) into the M1 and M2 slots. Plug the
Control Switch (E) into HS slot.
STEP 1: PREPARATION
Unpack and identify all parts. Place Table Top (G)
upside down on padded surface and identify front
edge.
Telescoping Legs
Support Braces
Feet and levelers
Table Top
Controller & Switch

STEP 4: FEET ATTACHMENT
Position Feet ( B) over the bottom of Telescoping Leg (A)
and align mounting holes. Attach using four M8 Fasteners
(H) but do not completely tighten. The mounting plate on
the Telescoping Leg (A) will swivel allowing the foot to be
aligned properly. Securely holding the foot in the proper
alignment with the Table Top (A), fully tighten the
fasteners. Attach four Levelers (N) or optional casters.
STEP 5: OPERATION AND USE
Gently turn table over and adjust Levelers (N) if required. Table
adjusts up and down using the Control Switch (E). Clean with
soft cloth and mild cleaners suitable for furniture.