Powder River 005-00180 User manual

PORTABLE SWEEP TUB
ASSEMBLY INSTRUCTIONS
#005-00180
www.powderriver.com
1-800-453-5318

Page 2
10/25/02 www.powderriver.com
005-00180 PORTABLESWEEPTUBASSEMBLY INSTRUCTIONS
STEP 1:
Pace the hinge side of the Sweep Bow
Gate where the center of the sweep will
be located. Then take the four Bottom
Braces and raise the end opposite of the
Bottom Brace Plate in the air, until the
tab on the Brace Plate can be slid into
the slot which is located on both sides
of the Bow Gate, as shown in figure 1.
CAUTION!
GATES AND PANELS ARE HEAVY
AND WILL FALL OVER IF NOT
PROPERLY SUPPORTED WHILE
BEING INSTALLED!
NOTE: The slots on the Bow Gate are for assembling the sweep tub on either side of the gate. When assembling
the tub on the opposite side of the Bow Gate as shown, you will need to move the Gate Latch to the other side of
the gate. You will also need to move the far left Bottom Brace to the open hole on the right side of the Brace
Plate.
STEP 2:
Position the ends of the Bottom Braces
about 45º apart as shown in figure 2.
1-800-453-5318

Page 3
10/25/02 www.powderriver.com
005-00180 PORTABLESWEEPTUBASSEMBLY INSTRUCTIONS
STEP 3:
Place the Top Braces one at a time
onto the Connector Pegs and
through the Top Brace Pin. Secure
the Top Braces by inserting the
Hairpin through the Brace Pin, as
shown in figure 3.
STEP 4:
Beginning with the Curved Panel
closest to the Bow Gate, slide each
panel into place one at a time.
Secure each Curved Panel and Top
Brace together by placing a pin
through the panel clips and
clevises, as shown in figure 4.
(Refer to figure 5 for a picture of
the panels secured together.)
1-800-453-5318

Page 4
10/25/02 www.powderriver.com
005-00180 PORTABLESWEEPTUBASSEMBLY INSTRUCTIONS
STEP 5::
Slide the 10’ Panel With Bow into place. Secure it to the Bow Gate by placing the pins through the panel clips
and clevises. Then secure it to the Curved Panel and Top Brace as shown in figure 5.
Slide the 10’ Panel With Bow into place. Secure it to the Bow Gate by placing the pins through the panel clips
and clevises. Then secure it to the Curved Panel and Top Brace as shown in figure 5.
1-800-453-5318