Prem-I-Air EH1622 User manual

1
EH1622
16" (40cm) Remote Control Wall Fan
3 speed, Adjustable
User Manual

2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.
Assembly
To assemble the fan;
Remove the grille lock nut(4) from the motor shaft(6)
Fit the rear grille by positioning the locating pins in the horizontal slots on
the grill. Secure the grill to the body with the grille lock nut(4)
Push the fan blade (3) onto the motor shaft (6) positioning the slots on the
rear of the blades in the shaft pin on the motor shaft.
Secure the fan blades using the fan blade nut (2), noting that the nut has a
left handed thread (turn anti-clockwise to tighten).
Open all the securing clips around the front grille(1) and loosen the securing
screw(14).
Line up the screw(14) with the corresponding hole in the rear grille and
tighten
Line the front grille (1) with the rear grille (4) and press the front grill firmly
into position. Close all the clips and tighten the safety screw.
The remote control takes 2 AAA batteries. Remove the rear cover of the
remote control and insert the batteries, taking care to observe the correct
polarity.

3
Installation
Before installation select a suitable location for the fan where it is unlikely to
cause an obstruction.
Draw a vertical centre line approx. 40mm long on the wall
Draw a horizontal line to mark the centre line for the screw holes approx.
30mm long.
Now mark 2 holes 10mm either side of the centre line.
Drill holes on the marked points using a 6 mm (¼") masonry bit, and insert a
wall-plug.
Insert the screws and tighten to 2-3mm from the wall..
Slide the fan onto the screws and ensuring the fan is fully down on the
keyhole slots and the fan cannot pull away from the wall.
OPERATION
Plug the mains lead into a 13 Amp mains socket. If any other appliances are
connected to the same extension lead, make sure that it is rated for the total
power of all appliances connected.
If connecting via an extension lead, make sure that the lead is rated at 3
Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
The unit can be operated by the use of either the control buttons on the
panel or the supplied remote control.
Use the On/Speed button to start the fan, initially the fan will operate at low
speed. Press the On/Speed button to choose between Low/Medium and
High Speed
The swing button allows the unit to oscillate the fan head to cover a greater
area.
To switch Off push the OFF button.

4
Timer : repeatedly pressing the timer button will cycle through the 0.5,1,2,& 4
hour settings allowing a time selection of between 0.5 & 7.5 hours. At the
end of the selected time the fan will stop. For continuous operation do not
touch this button.
Mode : The fan has 3 pre-set modes,
oNORmal for everyday use, and will operate as per the
set fan speed.
oNATural: operates to the following pattern depending
upon the fan setting:
o
oSLEep: In this operating mode the fan will operate at
the set speed for half an hour then drop to the next
lowest setting for another half an hour then operate at
its lowest speed setting till the fan turns off.
It is normal for the motor to become warm in normal use.
Unplug the appliance from the mains when not in use.
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill. At
this cost, the EH1522 will cost 20p per day to run on the "low speed" setting, or
33p per day to run on the "high speed" setting.
PAT TESTING
When used in an office environment, we recommend that this product should be
safety-tested yearly by a qualified electrician (PAT Tested).
We recommend that it is PAT tested regularly when used in a domestic
environment.
High Speed
Med Speed
Low Speed
H
M
L
H
M
L
H
M
L
Secs

5
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least
once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory
for new buildings). DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and disposal
is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your retailer
may take the old appliance for disposal.
PRODUCT SAFETY
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
Do not use in close proximity to gas appliances
Do not use unless correctly installed.
Do not cover when in use.
Do not place the mains lead beneath a carpet or rug.
Do not use the appliance in locations where paint, petrol or other flammable
liquids are used or stored.
Do no insert any object into the appliance through the grilles. This may
damage the appliance or result in overheating or electric shock.
Do not use this appliance in the immediate surroundings of a bath, a shower
or a swimming pool.
The appliance is fitted with an overload cut-out which will operate if the motor
overheats or is stalled. If this happens, disconnect from the mains supply
immediately, and allow the motor to cool down.

6
MAINTENANCE
Before cleaning, turn the appliance off, and disconnect from the mains supply.
The appliance may then be cleaned using a damp cloth with a drop of washing-
up liquid to remove any dust or dirt from the case. Do no use stronger detergents
or solvents as these may damage the paint finish.
Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or and
authorised service centre.
If the mains plug needs to be replaced, proceed as
follows:
Connect the brown wire to the terminal labelled "L".
Connect the blue wire to the terminal labelled "N".
Make sure that the cord-grip is positioned correctly
(over the outer sheath of the cable) and it fully
tightened.
If the plug is fitted with a 13 A or 5 A fuse, replace it
by a 3 A fuse.
TECHNICAL SPECIFICATION
Dimensions: 440×320×500 mm
Weight: 2.6 kg
Power supply: 230 V ~
Power consumption: High Speed 45 W
Air flow High Speed 2900 m3/h
Operating current: High Speed 0.17 A
Air speed: 6.4 m/s
Noise (max.): 60 dB(A)
Service value: 1.07 m3/W./min

7
SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in materials and workmanship for a
period of twelve months.
Should this appliance be operated under conditions other than those recommended, at
voltages other than the voltage indicated on the appliance, or any attempts made to service
or modify the appliance, then the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations. This warranty is in
addition to, and does not affect, your statutory rights.
Our guarantee is administered by our retailers.
If your product arrives damaged, you must contact the retailer from whom you bought it.
The retailer's contact details will be on the invoice that arrived with the product, or on the e-
mail you received when you placed the order. Do not contact Prem-i-air, only your retailer
can arrange a replacement.
If your product fails within the guarantee period, firstly read the "fault finding" section of this
manual, because temperature and weather conditions can affect the performance of certain
products. If the product needs to be repaired or replaced, you must contact the retailer from
whom you bought it.
The retailer's contact details will be on the invoice that arrived with the product, or on the e-
mail you received when you placed the order.
If you have just received your product and require technical help in using it, please call our
Help Desk on [phone]
If you have any other technical queries about the product, please call our Help Desk on
[phone].
Prem-i-Air Appliances Ltd.,
Lancots Lane, Sutton,
St. Helens, Merseyside.
WA9 3EX
website: www.prem-i-air.com