Presentation Switchers PS100 User manual

Page 1PS100 Quick Start Guide
Getting to Know the PS100
Getting to Know the PS100
The graphic below points out key aƩributes of the PS100.
Front View
Back View
Connections
Connections
Inputs and Outputs. Using the graphic above, connect the source devices to the ports labeled,
“Connect Source Devices Here”, as a reference and the display at locaƟon, “Display Output”,
port. Connect audio, if applicable.
Power. Connect the DC power supply to the locaƟon, “DC/5V”, and the other end to a 110V/
VAC power socket. The system LED will illuminate just below and to the leŌof the DC/5V
locaƟon.
Front ViewFront View
Quick Start
Connect Sources Devices Here
IR (Infra-Red) Sensor
Source Selector Active Source Indicator
Back Vie
w
Back Vie
w
Source “Port”
Stereo Audio Output
Display Output
USB Firmware Update
EDID Resolution Select

Page 2 Presentation Switchers, Inc.
Selecting a New Source Device to Display
Selecting a New Source Device to Display
To display a new source, press the Source Selector buƩon on the Front of the PS100 repeatedly
unƟl the LED on the AcƟve Source Indicator corresponds to the desired Source Port SelecƟon.
The image should now be visible on the Display Output and can be heard on the Stereo Audio
Output connectors.
Note: SelecƟng an input for a source that is not physcially connected will cause the output
display to indicate that the signal has been lost or disconnected.
Selecting a New Source Device to Display
Selecting a New Source Device to Display
(Using IR Remote)
(Using IR Remote)
From the IR Remote controller, shown below, select the Right or LeŌbuƩons unƟl the desired
Source is selected. If the front panel is viewable, you will see the AcƟve Source Indicator change
when each buƩon is pressed.
(Hand - Not to Scale)