Prima Klima LuciLu e-ballast 250W User manual

www.growland.net / www.growland-hydroponics.com
https://www.growland.fr / https://www.growland.co.uk
https://www.growland.es / https://www.growland.at
https://www.growland.nl / https://www.growland.it
https://www.growland.se / https://www.growland.pl

LuciLu
e-ballast
Power Pack 250W, 400W & 600W
Congratulations ! You now have one of the best quality digital power pack for HID lighting that money can buy.
Before you switch on any part of the lighting system, please make sure you get the safest use from the unit by taking
some time to read this important information.
Safety Advice
•
This product is intended for use with HID lamps and HID reflectors only.
•
Electricity can kill, so always use a Residual Current Breaker (RCB) with this product.
•
Before doing anything with the unit, make sure that the power supply is disconnected.
•
Keep away from children, pets and water. Suitable for indoor use only
•
The lamp will get hot during use. If the lamp has been on, leave it to cool for at least 30 minutes before touching
it and never touch the lamp while it is switched on !
•
Never switch the unit on without a reflector and lamp plugged in to it.
•
Make sure you use a reflector and lamp that is compatible with the unit. If in doubt ask your supplier.
•
Never tamper with the unit as there are no user serviceable parts inside and this will void the guarantee.
•
Only use the cable provided to connect the power pack to the mains.
•
Reflector cable length should be less than 5.5m. and mineral insulated cables are not suitable.
•
Not suitable for use with an external or lamp based ignitors.
• Do not cover the unit
Installation
Make sure the power to the unit is off. Mount the power pack on a sturdy, non-flammable surface. Make Bure any
protective plastic coverings on the reflector are removed before switching on the system.
Mount the reflector in a suitable Position then screw the lamp into the reflector's socket firmly to ensure a good
electrical contact. It is important that the lamp is free from smears, fingerprints etc. Wipe with a clean dry cloth
before use.
Plug the cable from the reflector into the power pack, ensuring the connectors are firmly pushed together. Switch
on the power and the lamp will ignite. After igniting, the lamp will illuminate to full brightness within 5 minutes.
To prolong the life of the lamp, always allow the lamp to fully warm up for 5 minutes before switching it off. After
switching the unit off, leave it off for 15 minutes before switching it back on again.
Troubleshooting
The power pack will attempt to ignite the lamp every 60 seconds until it ignites. If the system fails to start after 5
minutes (15 minutes for a Metal Halide lamp), then switch it off, remove the lamp and screw it back in again firmly.
Switch the unit back on and if the lamp still fails to ignite, contact your supplier.
Guarantee &
Liability
In the unlikely event that you find fault with this product, please contact your supplier. Maxibright DigiLight power
packs carry a 1 year guarantee (terms & conditions apply), excluding faulty fuses and tampering. The manufacturer
shall not be responsible for any damage caused by operation of the unit, be it incidental or consequential; or of any
type; including, without limitation, damage or injury, caused to other products, machinery, or buildings. Nor will
responsibility be accepted for loss of time or profit, loss of finished product, or for any inconvenience caused in any
way whatsoever.
3PAC-INS4001A