Primus ARCUS90T User manual
ARCUS90T USER GUIDE
2
I. PRODUCT
LAYOUT
3
1. Flexible and detachable microphone
2. Volume slider bar
3. 4-pole TRRS 3.5mm cable
4. Play-Pause/Previous and Next track in music playback mode
Pick up or end calls in phone mode
5. Female TRRS connector to TRS splitter (2x3.5mm)
6. Left and right earphones with gel ear fins
1
6
2
4
3
5
4
System requirements
• PS4TM and XBOX ONE®*
• Any 3.5mm TRRS and/or TRS compatible audio devices
*Xbox One controllers with no 3.5mm port will require an adapter (Xbox stereo
headset adapter is not included).
II. INITIAL SETUP
5
III. HOW TO
ATTACH THE
FLEXIBLE
MICROPHONE TO
THE EARPHONES
a. Insert the detachable microphone’s 2.5mm input plug into the jack, located on the left
earphone.
b. Adjust the flexible stem to better suit the user’s preferences. The microphone can be
completely detached when not needed.
c. When the detachable microphone is plugged in, the in-line microphone will be disabled.
6
IV. HOW TO USE
THE EARPHONES
Note: The multifunction feature is also accessible in phones.
PRESS THIS BUTTON ONCE
PRESS THIS BUTTON THREE TIMES
PRESS THIS BUTTON TWICE
PRESS THIS BUTTON ONCE WHEN THERE IS AN INCOMING CALL
PRESS AND HOLD THIS BUTTON FOR ABOUT 3 SECONDS
PRESS AND HOLD THIS BUTTON TO ACTIVATE THIS FUNCTION
a. Connect the audio plug in any smartphone, tablet, computer, laptop, or any device
compatible with a 3.5mm input.
Note: For computers, a TRRS to TRS cable may be required.
b. Slide up or down the volume bar on the in-line control capsule to increase or decrease
the audio level of the earphones.
c. Use the multifunction button to:
7
- Use the in-line control to increase or decrease the volume by sliding the switch up or down.
- Use the Multifunction button (ícono) to:
V. HOW TO CONNECT
THE EARPHONES
TO A 3.5MM TRRS OR TRS
AUDIO DEVICE
a. Connect the 4-pole TRRS plug into the
device's 3.5mm audio input of your choice.
Refer to Fig. A.
b. Connect the supplied 4-pole cable into the
jack of the TRRS to TRS splitter cable. Fig. B.
- Insert the plug with the pink jacket in the
corresponding port of your device to
connect the microphone, and the plug with
the green jacket in the corresponding port
to connect the audio.
Fig. A.
Fig. B.
8
1. Connect the earphones’ 3.5mm plug into a controller’s 3.5mm port.
2. Connect the earphones' 3.5mm plug into the 3.5mm port of the headset adapter for
the Xbox controller.
*Xbox One controllers with no 3.5mm port will require an adapter (Xbox stereo headset
adapter is not included).
VI. XBOX ONE
SETUP
9
a. Connect the earphones’ 3.5mm plug into a PS4 controller’s 3.5mm jack.
b. Go to Settings, then go to the Devices tab, select Audio devices, followed by Output
to headphones, and lastly the Select all audio tab.
VII. PS4 SETUP
10
VIII. TECHNICAL
SPECIFICATIONS
11
Primus®is a registered trademark. All rights reserved. XBOX ONE®is a registered trademark of Microsoft Corporation. PS4™ is
a registered trademark, and PS4™ PRO is a trademark of Sony Computer Entertainment Inc. These trademark owners do not
sponsor or endorse our products. Any mention of such is only intended for identification purposes, and is not to be construed
as a primusgaming.com claim to any rights pertaining to, sponsorship by, or affiliation with, those brands. Made in China.
3.5mm wired gaming earphones
In-ear
10mm
10mW
10mW
20-20kHz
32Ω
110dB+/-3dB
<3%
110dB±3dB
External and in-line
Electret condenser microphone
Omnidirectional
100-10kHz
2.2kΩ
-38dB±3dB
Slider bar
3.5mm stereo
In line: Play/Pause, Vol. +/Next track, Vol. -/ Previous track
Pick and end calls when in phone mode
47.2x0.9x0.8in
0.8oz
4.1ft
Two-year limited
This manual suits for next models
1
Table of contents
Other Primus Headset manuals
