
Instruction manual
6
BEFORE THE FIRST USE
• Turn the appliance upside down and place it on a soft surface to
prevent scratching of the housing.
• Screw off the wing nuts from the U-shaped bolt, and place the U-
shaped bolt between the most outer fins with the threaded ends
pointing upwards.
• Place the castor mounting plate over threaded ends of the U-
shaped bolt and screw on the wing nuts.
• Place the device on a flat stable surface and ensure a minimum
of 10 cm. free space around the device. This device is not
suitable for installation in a cabinet or for outside use.
• When the device is turned on for the first time, a slight odour will
occur. This is normal, ensure adequate ventilation. This smell is
only temporary and will soon fade.
USE
• Turn on the power, the device goes in stand-by mode. Only the
power button indicator will be on.
• Press the power button to turn the device on, all the buttons and
the display will be on.
• Press the power button again to shut down, all goes off, only the
power button indicator stays on.
Power setting
• In the power-on state, press "mode" to enter the pre-programmed
function settings, P1: 800W, P2: 1200W, and P3: 2000W.
Continue to press "+" or "-" to adjust to the desired setting, after
no operation for 3 seconds, the device will automatically exit the
setting state and return to the temperature display interface. (The
default boot position of the machine is P3)
Temperature setting
• In the power-on state, press "mode" twice to enter the set
temperature display, the temperature content will flash, continue
to press "+" or "-" to adjust the set temperature, the setting range
is "10-35 ⁰C". After no operation for 5 seconds, the device
automatically exits the setting state. The product automatically
controls heating on or off according to the difference between the
ambient temperature and the set temperature. (When the
temperature reaches the set temperature and stops heating, the
over-temperature warning light will be lit)
Timer setting
• In the power-on state, press "mode" three times to enter the timer
setting, the display shows "0", keep pressing "+" or "-" to adjust
the set time, the timer can be set from 1H to 24H. After 5 seconds
of no operation after setting the timer, the device will return to the
temperature interface and start the timer automatically. After the
set time has elapsed, the machine switches off and enters
standby mode. (The corresponding timing indicator lights up in
the timer status)