Printek FieldPro 641 User manual

© 2023 Printek LLC, 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:800-368-4636
www.printek.com
Printer features
Media Battery
FieldPro 641
Quick Start Guide
This guide provides information on the daily use of the FP641 printer.
For additional information, please refer to the FP641 User Guide.
BEFORE you begin, please visit www.printek.com Support, Downloads, Drivers and
Software, to download the FP641 printer driver.
The battery icon on the
display will indicate the
battery level.
Depress the
battery door clip
and pull battery
out.
Press Paper door release button to open the
paper compartment door. Insert roll into paper
holder lining up media roll core with core holder.
Pull small leader of paper out and close paper
door. “Clicks” when properly closed.
Disposal
Please dispose the batteries separately and free of cost at your
sales agency or the designated local collecting points.
Therefore please consider the national recycling standards!
Disassembly and removal of the batteries are described in the
User Guide.
Paper door release button
USB Data Port
Power Button
Control Panel Display
Paper Door
Charge Port
Shoulder strap attachment points
Belt loop attachment point

© 2023 Printek LLC, 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:800-368-4636
www.printek.com
Control Panel indicators
POWER & PAPER FEED
FUNCTION
HOW TO:
Power &
Status
(Green)
Power &
Status
(Yellow)
Power &
Status
(Red) Indication
Power Button
Power up &
Power down
Press & hold for
~ 3 seconds
On Off Off Power supplied by
battery
Access Web page *
Press 2 times to enter
Press 2 times to exit
On Off Off
Power supplied by
adapter
Paper feed button
Advance paper
Press and hold
Off
On
Off
Charging battery
Self-test print
Press 2 times rapidly
Off
Off
On
Booting up
Off
Off
On
Power on/off
DISPLAY NAVIGATION:
FUNCTION
HOW TO:
Off
Off
On
Battery failure
Menu button
Menu set up
Press 1 time
Flashing
(If no
battery is
charged)
Flashing
(If battery is
being charged)
Config mode
Paper feed
button
Scroll down
Press to scroll down
Menu button
Select category
Scroll up
Press 1 time
Press 1 time.
Power button
Save setting
Go back
Return to main
menu
Press 1 time
Press 2 times
Press 3 times
Dual radio FP641
Dual Radio printers arrive with Wi-Fi and BT modules set to Discover “ON”. If desired, go to “BT Config” or “Wireless Config” to set a radio to “OFF”
USB Access to Printer Web Pages
1. Press and hold the POWER button for 3 seconds to power on the printer.
2. Connect a USB cable between the printer and a PC.
3. * To access the FP641 web page, press the Power button twice rapidly. This will put the printer into Configuration mode.
4. When the printer is in Configuration mode the Power LED will flash.
a. Open browser on your PC and type 169.254.200.1 into the address bar of the browser and hit Enter - A login box should appear:
b. Type “0000” and hit Enter- you should now be at the home page for FP641 Configuration.
5. To return the printer to normal operating mode, double click the POWER button. The Power LED will be returned to a solid light.
Once the printer is connected via USB and in IP over USB mode it is
temporarily not possible to access the Internet.
FP641 Quick Start Guide
Some country specific Windows Operating Systems have not
activated or installed the RNDIS driver to use the IP-over-USB
mode. Therefore, please refer to our web site www.printek.com
support, downloads, drivers and software, to download the
RNDIS driver.