Printek I80 User manual

© 2021 Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:800.368.4636
www.printek.com
Printer features Media (8.5’’)
Printer can accept roll paper, fanfold or single sheet paper.
LOADING PAPER :
Roll Paper –
•Open the paper door by inserting your finger into the cutout in the paper door and gently pulling the door toward the front of the printer.
•Insert the leading edge of the paper roll into the printer with the coated side down.
•Close the paper door and push the paper feed button to insure the paper is under the roller and able to advance.
Black Mark Paper –
•Open the paper door by inserting your finger into the cutout in the paper door and gently pulling the door toward the front of the printer.
•Insert the leading edge of the paper roll into the printer with the black mark facing up.
•Close the paper door and push the paper feed button to insure the paper is under the roller and able to advance. If the printer is properly
configured for Black Mark paper the paper should advance until the black mark is detected by the printer.
Single Sheet Paper -
•Insert the single sheet of paper with the coated side down into the top of the printer.
•The printer will grab the single sheet and place it into the printer ready to print.
•If the printer has received a print job, the printer will begin to print as soon as the paper is detected.
I80 Quick Start Guide
Quick Start Guide
This guide provides information on the daily use of the I80 printer.
For additional information, please refer to the I80 User Guide.
USB Data Port
Power Port
Status LEDs
Paper door release
Paper Door
BEFORE you begin, please visit www.printek.com Mobile Printers; Service and Support;
Drivers and Software, to download the I80 printer driver.
Paper Door Open
Control Panel

© 2021 Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:800.368.4636
www.printek.com
Control Panel indicators
Control Panel
Power Button
Power Up
Power Down
Toggle
IP over USB
on/off
Press & Release
Press & Hold
Press twice
Paper Feed Button
Advance paper
Print Setup Report
Press once(LF) or long (FF)
Press twice
Power & Status
(Green/Red) (Yellow)
Alert
(Red) Indication
On
Off
On
Booting up(
…
20 sec!)
On
Off
Off
Ready
On
Off
Flashing
Paper Error/Lid Open
Flashing
Off
Off
Job is arriving
Flashing
Off
Off
Job is printing
Flashing
Off
Flashing
IP over USB active
Flashing Flashing Flashing Restart the printer manually
Off Off Flashing Restore the printer firmware
Off Off On Print head too hot
Self-Test / Configuration print out
With power on, press the Paper Feed button twice quickly.
Accessing the Configuration Menus through USB
1. Turn the printer ON.
2. Connect a USB cable between the printer and a PC.
3. To access the I80 web page, push the Power button twice rapidly. This will put the printer into Configuration mode.
4. When the printer is in Configuration mode the POWER and FAULT LEDs will flash together.
A. Open browser on your PC and type 169.254.200.1 into the address bar of the browser and hit Enter - A login box should appear:
B. Type “0000” and hit Enter- you should now be at the home page for I80 Configuration.
5. Push the Power button twice rapidly to exit Configuration Mode.
I80 Quick Start Guide
Once the printer is connected via USB and in IP over USB mode it is
temporarily not possible to access the Internet.