PROAIM Airwave XL Shock Absorber Arm User manual

1
What’s In The Box
Please inspect the contents of your shipped package to ensure you have received everything that
is listed below.
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permied by the applicable copyright
statutes or in wring by the Publisher.
Airwave XL Shock Absorber Arm (VI-APRO-00)
Ass e mb l y M a n u a l
Airwave XL Dual Spring
Shock Absorber Arm
2x Sca Clamps Base Plate Castle Ring Castle Nut Wrench
Flight Case

2
Mount Isolator Arm onto Mitchell stand and
x it with Castle Ring by twisng.
Then ghten Castle Ring with the help of
provided Castle Nut Wrench.
Airwave Arm Setup
Loosen locking nuts of each spring. Turn
leveling springs clockwise to add tension as
well as to raise the arm, turning it
an-clockwise will release tension and lower
it. Aer seng, re-lock locking nuts of each
spring.
Spring Adjustment
In order to smoothen Spring Tension, turn
adjustment knob. If arm is too so, turn it
towards direcon of H (Hard). If arm is rigid
turn it towards the direcon of S (So).
NOTE: The valves should always be adjusted evenly and set idencally. Rebound and compression of
hydraulic valves should be set in such a way so that any loose swinging or vibraon of arm is eliminated.
To change from Over Slung to Under Slung,
remove all bolts - 3 from each side of Mitch-
ell Mount, which is aached on both sides of
the Arm.
Other Conguraons
NOTE: Adjust both springs equally.

3
NOTE: According to your need, you can aach
your Gimbal Mount both on top and boom of
Mitchell Plate.
Aer aaching your Ronin mount to Mitchell
Plate, ghten it with Castle Nut Wrench.
Then, Mount the setup, as shown in image.
Unscrew the bolts with the help of allen
key and remove Mitchell Plate from your
Arm.
Attach Base Plate with arm by matching
its hole and insert the bolt to tighten it.
Attaching Base Plate
NOTE: For attaching the Base Plate, firstly you need to detach Mitchell plate from Arm.
Now tighten the bolts with the help of
allen key to secure it properly.


4
Slide Sca Clamps onto the Arm & then
loosen the knob on clamps, as shown.
Now insert bolts into Sca Clamp and ghten
with the help of allen key.
Aaching Sca Clamps
Then aach Shock absorbing Arm with Pole
and ghten the Clamps appropriately to
secure the Arm.
YOUR PROAIM AIRWAVE XL SHOCK ABSORBER ARM
ALL DRESSED UP AND READY TO GO!
(SHOWN WITH OPTIONAL ACCESSORIES)

5
Warranty: We oer one year warranty for our products from date of purchase. Within this period of me,
we will repair it without charge for labor or parts. Warranty doesn’t cover transportaon costs nor does it
cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to inspecon
and evaluaon by us.
Liability: We are not liable for damage caused by products that we do not supply or from mishandling in
transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our company.
Contact Us: In case of any kind of dissasfacon, please Contact us immediately and we promise our
utmost support and care unl you use our product.