PROAIM CINEMA Series User manual

1
What’s In The Box
Please inspect the contents of your shipped package to ensure you have received everything that
is listed below.
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permied by the applicable copyright
statutes or in wring by the Publisher.
Gripmax Vibration Isolator Car Mount (CM-GPMX)
Ass e mb l y M a n u a l
Gimbal Vibraon Isolator
4 x Sucon Cups with Rosee Extension Arms
4 x Dust Covers
4 x Rubber Sleeves
Hard Case
2 x Safety Belts
Note: If you have purchased (CM-GPMX-00) kit, you will receive the following:

2
Remove dust cover and place your rst
sucon cup on selected posion where you
want to shoot.
Press down the sucon cup and keep pushing
pump to rmly x it on surface. Repeat this
process for all sucon cups.
Gripmax Setup
You can easily adjust/level angle of each arm
through the provided knob in 360° rotaon,
which gives extra exibility, and thus you can
mount cups to virtually any part of vehicle.
To guarantee proper adhesion of sucon cups, check that the surfaces of cup & mounng surface are
clean, dry & dust-free. Please mount it on smooth, even & non-porous surfaces.
Gimbal Vibraon Isolator
4 x Sucon Cups with Rosee Extension Arms
4 x Dust Covers
4 x Rubber Sleeves
Flight Case
2 x Safety Belts
Note: If you have purchased (CM-GPMX-01) kit, you will receive the following:

3
Aach Gimbal Vibraon Isolator Plate with
Rosee Extension Arms and secure it
carefully by ghtening the knobs.
There is a provision to mount V-mount
battery (Not Included) on V-mount battery
plate.
Although the Gripmax’s holding force is
adequate for regular driving shots, safety
belts/tension straps must be used for
addional security. When mounted on cars,
the objects aached to Gripmax (e.g. camera,
gimbal, etc.) have to be secured addionally.
Use rubber sleeves to avoid dents and
scratches on car paint. Tighten tension straps
carefully to avoid damages.
Note: Test all xtures before driving.
You can extend the length of Rosee Arms
from 12.5cm to 17.5cm with help of red knob
as per your setup requirement.
Adjust/rotate ARRI Standard Rosee bearings
up to 270° to your requirements, with help of
provided knob.

4
Warranty: We oer one year warranty for our products from date of purchase. Within this period of me,
we will repair it without charge for labor or parts. Warranty doesn’t cover transportaon costs nor does it
cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to inspecon
and evaluaon by us.
Liability: We are not liable for damage caused by products that we do not supply or from mishandling in
transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our company.
Contact Us: In case of any kind of dissasfacon, please Contact us immediately and we promise our
utmost support and care unl you use our product.
YOUR PROAIM GRIPMAX VIBRATION ISOLATOR SUCTION CAR MOUNT
ALL DRESSED UP AND READY TO GO!
(SHOWN WITH OPTIONAL ACCESSORIES)