progeo Raptor User manual

Progeo Raptor Installation Guide
!
1. The optimum position for the clamps is
approximately 32 - 33cm from the bottom of
the clamp to the floor. "
When tightening the bolts tighten in
increments starting with the two rear bolts
followed by the single front bolt."
If the wheel chair frame is >10 degrees either
side of 90 then the clamps can be rotated to
horizontal by loosening the large bolt.
2. If possible use a spirit level to position the
second clamp as having the two clamps level
is more important then the floor height."
With round tubes you will also need to
ensure clamps are square. At this stage it is
easiest to eyeball and fine tune later.
For trouble shooting call:"
Shanon - 027 727 1471
John - 021 295 5241

3. Put the three parts of the frame together
and insert the arms into the clamps until only
the black rubber end caps are visible at the
back of the clamps. "
Do Not tighten the clamps.
4. Press the arms together at the 90 degree
bend to ensure they are properly bedded in to
the front section."
Centre the front section."
Important: Before tightening the four pins in
the front section angle the frame up (stand
towards you - top towards wheelchair), this will
ensure plenty of lift when you attach the
Raptor."
Slide the arms all the way in. If it does not slide
in smoothly the clamps are not square but you
can now use the frame as a guide."
If the arms do slide smoothly then the final step
is to adjust the height of the stand to be
approximately 10cm from the floor."
See our website for video tutorials on docking and electric lift assist:
www.speedysnailmobility.co.nz/raptor
For trouble shooting call:"
Shanon - 027 727 1471
John - 021 295 5241