Progress PC4206 User manual

PC4206
PC4207
PC4208
PC4220
PC4260
PC4280
4501 02 03 03
ifu 42xx press.qxd 12/5/03 1:05 PM Page 1
All manuals and user guides at all-guides.com
all-guides.com

1
8
19. 20. 21.
26.
23.
22. 24.
25.
ifu 42xx press.qxd 12/5/03 1:05 PM Page 3
All manuals and user guides at all-guides.com

PROGRESS PC 4206, 4207, 4208, 4220, 4260, 4280
Hungarian
Polish
Croatian
Czech
Slovak
Francais
Nederlands
Italiano
English
Deutsch
ifu 42xx press.qxd 12/5/03 1:05 PM Page 5
All manuals and user guides at all-guides.com

English PROGRESS PC 4206, 4207, 4208, 4220, 4260, 4280
IMPORTANT SAFEGUARDS
 Read this instruction booklet carefully
 Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate
 Do not switch the appliance on if it appears to be faulty in any way or it has a damaged cord or plug Do not try to repair the appliance
by yourself For repairs or accessories, contact Electrolux Customer Services
 Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance
operations
 Never leave the appliance unattended when it is switched on Keep the appliance out of reach of children
 This appliance is for domestic use only Use as described in this instruction booklet
 Do not pull the appliance by the cord Do not unplug by pulling on the cord
 Do not use appliance on wet surfaces or to vacuum liquids, mud, ash and burning cigarette butts Do not vacuum up any highly flam-
mable or explosive substances or gases
 Do not unplug the vacuum cleaner with wet hands
 Do not operate the vacuum cleaner too close to heaters and radiators, stoves etc
 Before you start using the vacuum cleaner, please remove large or sharp objects from the floor to prevent damage to the cloth dust-
bag
INSTRUCTIONS FOR USE
 Before placing into operation make certain that the filters are in the proper position
 Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket A YELLOW mark on the
power cable shows the ideal cable length Do not extend the cable beyond the RED mark
 Press the ON/OFF button to switch the appliance on It is advisable to set the power control to MIN before switching the appliance on
 To rewind the power cable, press the rewind button with foot, and guide the cable with hand to ensure that it does not whip causing
damage
 By moving the variable power control, the suction power can be adjusted
DESCRIPTION
1 Suction inlet
2 Dustbag full indicator
3 Variable power control
4 Cable rewind button
5 On/off switch
6 Wheel
7 Dustbag compartment
8 Carrying handle
9 Compartment open button
10 Hose
11 Telescopic tube
12 Dual purpose floor nozzle
13 Upholstery nozzle
14 Combination crevice nozzle / brush
15 Dustbag
16 Vertical parking
17 Horizontal parking
18 Tools on board
- 1 -
ifu 42xx press.qxd 12/5/03 1:05 PM Page 7
All manuals and user guides at all-guides.com

- 2 -
MAINTENANCE
REPLACING THE DUSTBAG
 Always operate the cleaner with the dustbag installed
 If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not close completely
 After removing the flexible hose, open the front cover (fig 19)
 Remove the dustbag and insert a new one (fig 20, 21)
 Close the cover by pressing down until it clicks (fig 19)
 Dustbag reference number: T120 / CT 120
 Dustbag reference number in Switzerland: MI 06
REPLACING THE FILTERS
 The dustbag must be replaced if the window of the dustbag full indicator is completely red when the cleaner is operating at maximum
power and the nozzle is raised from the floor
 Filters should be replaced at least twice a year or when they become visibly soiled
 Always operate the cleaner with filters installed to avoid reduced suction
 Disconnect from electrical outlet before changing the filters
 Do not use a washing machine to rinse filters
 Pull dustbag upward and remove the motor protection filter (fig 22)
 Rinse the filter under tap water and dry it completely (fig 23)
 Put the filter back into the cleaner (fig 22 )
 Open the filter cover and remove the exhaust filter with grill (fig 24, 25) (PC 4206, 4207, 4220, 4260)
 Take the filters out of the grill (fig 26)
 Rinse the filters under tap water and dry them completely (fig 23)
 Place the filters back into the grill and put it back into the cleaner (fig 26, 25)
 Close the filter cover (fig 24)
 HEPA filter (PC 4208, 4280): Take out the filter with grill, and change it for a new one (fig 25)
PROTECTING THE ENVIRONMENT
 Attempt to recycle packaging material and old appliances
 The cardboard packaging can be placed in the waste paper collection
 Deposit the plastic bag made of polyethylene (PE) at the PE collection point for recycling
Recycling he Appliance a he end of i s life:
 The plastic components all carry a material identification marking so that, like the other materials, they can be recycled at the end of
the life of the appliance
 Please inquire with your local authority
Blocked air flow and dir y fil ers:
 The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt
 Disconnect from mains and allow the cleaner to cool for 20-30 minutes Remove blockage and/or clean filters
 Restart the cleaner
PROGRESS PC 4206, 4207, 4208, 4220, 4260, 4280
ifu 42xx press.qxd 12/5/03 1:05 PM Page 9
All manuals and user guides at all-guides.com